Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2004 BMW 5 Series, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
ZF Group North America Operations (ZF) is recalling certain Lemförder Steering Center Rods sold as aftermarket parts for 1996-2004 BMW 5-Series (E39) vehicles. The steering center rods may have an insufficient ball pin pull force that may allow the rods to detach from the steering knuckle. Remedy: ZF has notified the parts distributors, instructing them to inform the end customer. ZF will reimburse them for the affected parts. The recall began August 28, 2019.
BMW IS RECALLING CERTAIN MODEL YEAR 2004-2010 5-SERIES, MODEL YEAR 2004-2010 6-SERIES, MODEL YEAR 2006-2010 M5, AND MODEL YEAR 2007-2010 M6 VEHICLES. THE INSULATED BULKHEAD CONNECTOR FOR THE POSITIVE BATTERY CABLE MAY HAVE BEEN INCORRECTLY ATTACHED TO THE TRUNK FLOOR PANEL, WHICH CAN LEAD TO A LOOSENING OF THE BOLT CONNECTION. AS IT LOOSENS, AN INCREASE IN ELECTRICAL RESISTANCE AT THIS CABLE CONNECTION IS POSSIBLE AND COULD CAUSE THE CABLE CONNECTION TO OVERHEAT. Remedy: BMW WILL NOTIFY OWNERS, AND DEALERS WILL INSPECT AND SECURE THE BATTERY BOLT CABLE CONNECTION AS NECESSARY, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON APRIL 30, 2012. OWNERS MAY CONTACT BMW CUSTOMER RELATIONS AND SERVICES AT 1-800-525-7417.
BMW IS RECALLING 200,000 MY 2006 3 SERIES SPORT SEAT, MY 2004-2006 5 SERIES STANDARD AND SPORT SEAT, AND MY 2004-2006 X3 PASSENGER VEHICLES. DEPENDING ON THE MANNER AND FREQUENCY OF THE FRONT PASSENGER'S ENTRY AND EXIT, SMALL CRACKS HAVE DEVELOPED IN THE MAT. IF THIS OCCURS, THE FRONT PASSENGER AIR BAGS, WITH THE EXCEPTION OF THE HEAD PROTECTION SYSTEM, WILL BE DEACTIVATED AND THE AIR BAG WARNING LAMP AS WELL AS THE PASSENGER AIR BAG "ON-OFF" LAMP WILL BE ILLUMINATED. Remedy: DEALERS WILL REWORK THE FRONT PASSENGER SEAT SENSOR MAT SO THAT EXTERNAL FORCE APPLICATION TO THE SEAT DOES NOT CAUSE A CRACK TO THE MAT. THE RECALL BEGAN ON NOVEMBER 6, 2008. BMW WILL ALSO EXTEND THE WARRANTY ON THESE VEHICLES TO 10 YEARS FROM FIRST REGISTRATION WITHOUT ANY MILEAGE LIMIT. OWNERS MAY CONTACT BMW AT 1-800-525-7417.
This recall involves aftermarket parts sold by Valeo. Valeo is recalling certain engine cooling fans, part numbers 696121, 696273, and 696275, used as service replacement parts for model year 2008-2011 BMW 1-Series, 2006-2011 BMW 3-Series, 2000-2009 BMW 5-Series, 2004-2005 BMW 6-Series, and 2006-2007 BMW 7-Series vehicles. A metal-oxide semiconductor may overheat due to insufficient screwing of the semiconductor on the aluminum heat sink. This primary failure could cause adjacent components on the fan assembly motor circuit board to overheat and short. Remedy: Valeo will notify owners and replace the fans free of charge. The safety recall began on August 22, 2012. This recall is being conducted by Valeo, not by BMW. For further information, owners may contact Valeo at 1-888-718-2536.
BMW IS RECALLING CERTAIN MODEL YEAR 2004-2010 5-SERIES, 6-SERIES, AND MODEL YEAR 2002-2008 7-SERIES VEHICLES. A CHECK VALVE OF THE BRAKE VACUUM PUMP MAY LEAK A SMALL AMOUNT OF LUBRICATING OIL. OVER TIME THIS COULD RESULT IN CONTAMINATION OF THE BRAKE BOOSTER. Remedy: BMW WILL NOTIFY OWNERS AND DEALERS WILL REPAIR THE VEHICLES FREE OF CHARGE. THE SAFETY RECALL BEGAN ON NOVEMBER 24, 2010. OWNERS MAY CONTACT BMW AT 1-800-525-7417.
ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH FRONT SEAT HEATING SYSTEMS, UPON ENTERING AND EXITING THE VEHICLE, EXCESSIVE CONTACT WITH THE SIDE BOLSTER THAT IS CONTAINED IN THE SEAT'S BACKREST MAY DAMAGE THE HEATING MAT LOCATED IN THIS AREA. IF SUCH DAMAGE WERE TO OCCUR, WITH THE SYSTEM TURNED ON, THE VEHICLE OCCUPANT MAY FEEL EXCESSIVE HEAT FROM THIS AREA. Remedy: DEALERS WILL MODIFY THE SEAT HEATING CIRCUIT. THE RECALL IS EXPECTED TO BEGIN DURING DECEMBER 2004. OWNERS SHOULD CONTACT BMW AT 1-800-831-1117.
ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH 8 AND 12 CYLINDER ENGINES, THE DIGITAL ENGINE MANAGEMENT CONTROL (EMC) UNITS WERE NOT PRODUCED ACCORDING TO SPECIFICATIONS. Remedy: DEALERS WILL INSTALL A NEW DIGITAL ENGINE MANAGEMENT CONTROL UNIT. THE RECALL BEGAN ON JULY 16, 2004. OWNERS SHOULD CONTACT BMW AT 1-800-831-1117.
ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH 8-CYLINDER ENGINES, A CIRCULAR RETENTION CLIP AT THE QUICK-RELEASE COUPLING ALONG THE FUEL SUPPLY LINE WAS INADVERTENTLY NOT INSTALLED. Remedy: DEALERS WILL INSTALL A CIRCULAR RETENTION CLIP AT THE QUICK-RELEASE COUPLING ALONG THE FUEL SUPPLY LINE. THE RECALL BEGAN ON JULY 5, 2004. OWNERS SHOULD CONTACT BMW AT 1-800-831-1117.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, the insulated bulkhead connector (used to join the two halves of the positive battery cable) may have been incorrectly installed during vehicle assembly. Over time, the bolt connection could loosen, which would increase electrical resistance. In addition, an incorrectly insulated bulkhead connector could allow humidity to accumulate at this location, causing current leakage. These issues could cause the cable connection to overheat, which could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will inspect and, as necessary, secure the insulated bulkhead connector. In addition, protective grease will be added to the area and the plastic battery positive terminal cover will be replaced.
On certain vehicles, a check valve in the brake vacuum pump may leak a small amount of lubricating oil. Over time, this could result in contamination of the brake booster. Loss of brake power assist could occur which, in conjunction with traffic, road conditions, and driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the brake booster and master cylinder. Additionally, the brake vacuum line (including the check valve) will be replaced to eliminate the possibility of oil reaching the brake booster.
On certain vehicles, the front passenger seat occupant detection mat can fatigue during field usage depending on the seat configuration, vehicle geometry, manner and frequency of front passenger entry/exit. Over time micro cracks could develop in the side flanks of the mat, which could lead to a break of the conductive path and the system will recognize a failure and with exception of head protection system the front passenger air bag will be deactivated. The airbag On/Off lamp will be illuminated to make the occupants aware of the deactivation. Correction: The occupant detection mat will be granted a warranty extension of 10 years.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles equipped with heated seats, excessive contact with the seat backrest side bolster upon entering and exiting the vehicle may damage the heating mat located in this area. If this happened, the seated occupant may experience excessive heat in this location. The heating mat could damage, or melt a small hole in the lower portion of the backrest's outboard side bolster. If this were to occur, an electrical/melting smell or small amount of smoke would be noticeable. In some cases, the small hole in the backrest's side bolster could damage the seated occupant's clothing. In rare instances, this could lead to a minor or superficial skin injury. Correction: Dealers will modify the seat heating circuit for the front seat backrests.
On certain vehicles, the digital engine management control unit was not produced according to specifications. As a result, engine stalling will occur after a short period of operation. The vehicle may not be able to be restarted. Also, a loss of power steering and, after repeated actuation of the brake pedal, a loss of brake power assistance will occur. If stalling were to occur, the driver would be unable to maintain vehicle speed or accelerate. Steering and braking, while possible, would be difficult. Depending on traffic conditions and the driver's reactions, this could lead to a crash. Correction: Dealers will replace the digital engine management control unit.
On certain vehicles equipped with an 8-cylinder engine, the circular retention clip at the quick-release coupling along the fuel supply line was inadvertently omitted. As a result, it is possible that in a severe frontal crash, the quick-release coupling could separate. If this happens, a small amount of fuel could leak and potentially ignite. Correction: Dealers will install a circular retention clip.