Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2004 Freightliner FLD, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
ON CERTAIN TRUCK AND MOTOR HOME CHASSIS EQUIPPED WITH I-SHAFTS SUPPLIED BY ZF HEAVY DUTY STEERING, THERE IS A POTENTIAL FOR A FAILURE OF THE FORK/SHAFT CONNECTION. Remedy: DEALERS WILL INSPECT AND ATTACH A TENSION COLLAR TO THE STEERING SHAFT TO SECURE THE CONNECTION TO THE YOKE. THE RECALL BEGAN ON NOVEMBER 16, 2005. OWNERS MAY CONTACT FREIGHTLINER AT 1-800-547-0712.
ON CERTAIN TRUCKS, THE BRAKE PEDAL PUSHROD WAS NOT TIGHTENED PROPERLY DURING ASSEMBLY. Remedy: DEALERS WILL ADJUST THE PEDAL PUSHROD. THE RECALL BEGAN ON APRIL 11, 2005. OWNERS SHOULD CONTACT FREIGHTLINER AT 1-800-547-0712.
ON CERTAIN VEHICLES, THERE IS A DEFECT IN THE INTERAXLE DRIVELINE YOKES. THE BOLT HOLES LOCATED ON THE EARWORK OF THE MALE SHAFT YOKES WERE MANUFACTURED WITH AN OVERSIZED MINOR THREAD DIAMETER. Remedy: DEALERS WILL REPLACE THE SUSPECT MALE SHAFT YOKES. THE RECALL BEGAN ON APRIL 4, 2005. OWNERS SHOULD CONTACT FREIGHTLINER AT 1-800-547-0712.
ON CERTAIN TRUCKS EQUIPPED WITH 3RD GENERATION CONMET ALUMINUM WHEELS, THE DRUM MOUNTING FLANGE ON THE CONMET TRUTURN BRAKE DRUM MAY HAVE BEEN MANUFACTURED WITH A TAPER FROM THE PILOT HOLE TO THE BARREL OF THE DRUM. Remedy: AFTER FURTHER INVESTIGATION AND TESTING, FREIGHTLINER HAS REVISED THE POPULATION AND THE REMEDY (DECEMBER 22, 2005). THEREFORE, THE RECALL BEGAN ON MARCH 15, 2006. OWNERS MAY CONTACT FREIGHTLINER AT 1-800-547-0712.
DAIMLER TRUCKS IS RECALLING CERTAIN MODEL YEAR 2004 THROUGH 2008 HEAVY TRUCKS MANUFACTURED FROM JULY 11, 2003, THROUGH SEPTEMBER 28, 2007, EQUIPPED WITH EPA04 MODEL MBE4000 ENGINES BUILT WITH PLASTIC LOW PRESSURE FUEL LINES AND FUEL FILTERS MOUNTED NEAR THE CENTER OF THE ENGINE ON THE LEFT-HAND SIDE. THE PLASTIC LOW PRESSURE FUEL LINE BETWEEN ENGINE MOUNTED FUEL FILTER AND ENGINE BLOCK MAY DEVELOP A SUBSTANTIAL DIESEL FUEL LEAK. Remedy: DAIMLER TRUCKS WILL NOTIFY OWNERS AND THE REMEDY WILL BE PERFORMED BY DETROIT DIESEL CORPORATION AUTHORIZED REPAIR FACILITIES. VEHICLES WILL BE INSPECTED AND THE PLASTIC LOW PRESSURE FUEL LINE WILL BE REPLACED WITH A STEEL LOW PRESSURE FUEL LINE. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. AN INTERIM LETTER WAS MAILED TO OWNERS ON OCTOBER 28, 2011. THE SAFETY RECALL BEGAN ON FEBRUARY 21, 2012. OWNERS MAY CONTACT DAIMLER TRUCKS AT 1-800-547-0712.
DAIMLER TRUCKS IS RECALLING MODEL YEAR 2004-2010 TRUCKS EQUIPPED WITH CATERPILLAR C15 ENGINE. THE VARIABLE VALVE ACTUATION OIL LINE MAY RUB AGAINST THE P-CLIPS RETAINING THE OIL LINE, CAUSING AN OIL LEAK. Remedy: DAIMLER TRUCKS IS WORKING WITH CATERPILLAR TO REMEDY THESE VEHICLES. PLEASE SEE CATERPILLAR'S DEFECT REPORT 09E-020. CATERPILLAR WILL INSPECT AND REPAIR THE NECESSARY COMPONENTS FREE OF CHARGE. THE RECALL BEGAN ON MAY 5, 2009. OWNERS MAY CONTACT CATERPILLAR TOLL-FREE AT 1-800-447-4986 OR DAIMLER TRUCKS AT 1-800-547-0712.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: Certain trucks were built with air reservoir tanks that are too small in relation to the size of the air brake chambers. Canadian regulations require enough air reservoir capacity to ensure the brakes work even with heavy use or when there is a partial loss of the air system. Safety Risk: Reduced braking could cause extended stopping distances and increase the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct them to take their truck to a Daimler Trucks North America authorized service facility to modify the truck to ensure it meets Canadian regulations.
On certain trucks, the plastic low-pressure fuel line between the engine-mounted fuel filter and the engine block may develop a diesel fuel leak. The location of the leak is unlikely to result in a vehicle fire; however, diesel fuel spilt on the roadway could endanger other road users by making the roadway unexpectedly slippery. This could ultimately result in a vehicle crash causing property damage and/or personal injury. Correction: Dealers will replace the plastic low-pressure fuel line with a steel version.
On certain vehicles equipped with a Caterpillar C15 engine, the Variable Valve Actuation (VVA) oil line may wear against the P-clip retaining the oil line. An oil leak could result in a vehicle fire causing property damage and/or personal injury. Correction: Caterpillar dealers will replace the VVA oil line with an updated version.
On certain vehicles, the rear suspension transverse beam castings were not made to specifications. If a casting were to break when the vehicle is in motion, parts could become projectiles with potential to cause property damage, personal injury or death. Also, the transverse beam may drop down low enough to contact the road surface causing sparks that could ignite a fire. Correction: Dealers will inspect and, if necessary, replace the transverse beams.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, the front hubs may fracture and allow the wheel assembly to separate from the vehicle. This could cause a crash without prior warning. Correction: Dealers will inspect and, if required, replace the hubs.
On certain vehicles, burner tubes in the Webasto DBW 2010 Scholastic coolant heater may begin deteriorating at an accelerated rate and could fail. Burner tube failure could result in an increase in exhaust gas temperature which could ignite combustible material in or around the vehicle. Correction: Dealers will replace the burner tubes.
On certain vehicles, bolt holes located on the earwork of the drive shaft male yoke were manufactured with an oversized thread diameter. This condition allows the bolts used in the holes to become detached which, in turn, could result in driveline separation. Correction: Dealers will inspect and, if necessary, replace the male shaft yoke subassembly.
On certain vehicles, the jam nuts on the brake pushrod between the pedal and the brake valve may not have been tightened, which could cause the brake pedal pushrod to become misadjusted. This could result in gradual loss in braking performance or a complete loss of brakes leading to a possible vehicle crash without prior warning. Correction: Dealers will tighten the jam nuts to the proper torque value.