Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2004 Hyundai Santa FE, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Hyundai Motor Company (Hyundai) is recalling certain model Year 2001-2006 Santa Fe vehicles manufactured from March 31, 2000, through February 15, 2006, that are registered and operated, or which were originally sold and registered, in the following 20 salt belt" states and the District of Columbia: Connecticut, Delaware, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia, and Wisconsin. The affected vehicles may experience front coil spring corrosion from road salt, causing the coil spring to fracture and make contact with the tire. Remedy: Hyundai will notify owners, and dealers will inspect and if necessary replace the coil spring, free of charge. The recall began on October 24, 2014. Owners may contact Hyundai customer service at 1-800-633-5151. Hyundai's number for this recall is 124.
CERTAIN SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS." Remedy: OWNERS WILL BE PROVIDED WITH A CORRECT LABEL AND INSTALLATION INSTRUCTIONS. OWNER NOTIFICATION BEGAN ON OCTOBER 29, 2003. OWNERS SHOULD CONTACT HYUNDAI AT 1-800-633-5151.
ON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH 3.5 LITER V-6 ENGINES, 4-WHEEL DRIVE AND ANTILOCK BRAKING SYSTEMS (ABS), IF THE BRAKE PEDAL IS DEPRESSED AT SPEEDS BETWEEN 3 AND 12 MPH WHEN THE BRAKE PAD FRICTION SURFACES ARE WET, A VIBRATION MAY OCCUR BETWEEN THE BRAKE DISCS AND PADS CAUSING ABS SENSOR ELECTRONIC SIGNAL NOISE TO DEVELOP. AT SPEEDS BELOW 5 MPH, THE ABS SENSOR SIGNAL NOISE MAY CAUSE THE ABS ELECTRONIC CONTROL UNIT (ECU) TO ACTIVATE THE ABS, EXTENDING THE STOPPING DISTANCE. Remedy: DEALERS WILL REPROGRAM THE ABS ECU. OWNER NOTIFICATION BEGAN ON MARCH 24, 2004. OWNERS SHOULD CONTACT HYUNDAI AT 1-800-633-5151.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, the front suspension coil springs may be susceptible to corrosion. Over time, corrosion could cause the springs to fail, potentially damaging front tires and causing rapid air loss and/or tire failure, which could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will inspect and replace coil springs as necessary. Additionally, a spring guide will be installed to prevent the coil spring from contacting the tire.
On certain vehicles equipped with a 3.5L V6 engine, 4wd and ABS, if the brake pedal is depressed at speeds between 5 and 20 km/h when the brake pad friction surfaces are wet, a condition called creep vibration may occur between the brake disc and pad. The ABS Electronic Control Unit may misinterpret the ABS sensor signal noise as indicating that the speed is above 7 km/h, causing it to activate the ABS, extending the stopping distance. Correction: Dealer will reprogram the ABS ECU.
On certain vehicles, the wheel rims and the tire pressure labels do not comply with CMVSS 120. The rims do not contain the required markings and the tire pressure labels do not contain the rim size. Correction: Hyundai will provide owners with a corrected tire pressure label. Since the non-compliant wheel rims do not pose any safety risk, no corrective action is required.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain