Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2004 Kenworth W900, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
ON CERTAIN TRUCKS, SOME OF THE HUCK BOLTS ON THE CAB MAY NOT HAVE BEEN PROPERLY INSTALLED. Remedy: DEALERS WILL INSPECT AND REPLACE THE HUCK BOLTS ON THE CAB ATTACHING STRUCTURE OF THE LEFT-HAND DOOR APERTURE, IF NECESSARY. THE RECALL BEGAN ON NOVEMBER 19, 2004. OWNERS SHOULD CONTACT KENWORTH AT 425-828-5440.
CERTAIN TRUCKS EQUIPPED WITH EATON FULLER ULTRASONIC TRANSMISSIONS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 102, "TRANSMISSION SHIFT LEVER SEQUENCE, STARTER INTERLOCK AND TRANSMISSION BRAKING EFFECT." THE CAB TRANSMISSION HARNESS COULD HAVE BEEN INCORRECTLY WIRED DURING PRODUCTION INSTALLATION. Remedy: DEALERS WILL REPAIR THE CONNECTIONS IN THE WIRING HARNESS IF NECESSARY. OWNER NOTIFICATION BEGAN ON MAY 7, 2004. OWNERS SHOULD CONTACT KENWORTH AT 1-425-828-5440.
ON CERTAIN TRUCKS BUILT WITH THE OPTIONAL DANA SPL DRIVELINE, THE U-JOINT FASTENERS AT THE OUTPUT YOKE OF THE TRANSMISSION WERE NOT PROPERLY TIGHTENED. Remedy: DEALERS WILL VERIFY THE TORQUE OF THE U-JOINT FASTENERS. PARTS SHOWING EXCESSIVE WEAR WILL BE REPLACED. THE RECALL BEGAN ON NOVEMBER 12, 2004. OWNERS SHOULD CONTACT KENWORTH AT 1-425-828-5440.
ON CERTAIN TRUCKS EQUIPPED WITH A COMBINATION OF CATERPILLAR C11/C13 ENGINES AND AN OPTIONAL LEECE NEVILLE BRUSHLESS ALTERNATOR, A CHAFFING POINT MAY EXIST BETWEEN A HEAT SHIELD ON THE ENGINE AND THE WIRING FOR THE ALTERNATOR. Remedy: DEALERS WILL CHANGE THE ALTERNATOR TO A BRUSH-TYPE ALTERNATOR THAT IS SHORTER IN LENGTH AND PROVIDE THE NECESSARY CLEARANCE TO ALL SURROUNDING COMPONENTS. THE RECALL BEGAN AUGUST 31, 2004. OWNERS SHOULD CONTACT KENWORTH AT 1-425-828-5440.
CERTAIN TRUCKS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, 'TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS.' THE TIRE PRESSURE WAS OMITTED FROM THE VEHICLE'S CERTIFICATION LABEL. Remedy: OWNERS WILL BE PROVIDED WITH A CORRECTED LABEL. THE RECALL BEGAN AUGUST 12, 2004. OWNERS SHOULD CONTACT KENWORTH AT 1-425-828-5440.
PACCAR IS RECALLING 130 MY 2004-2009 T2000, T800, T600, W900 AND T660 KENWORTH TRUCKS BUILT WITH AN AG400 REAR SUSPENSION, LONG STROKE BRAKE CHAMBERS, AND WIDE BASE TIRES (SUPER SINGLES). THESE VEHICLES MAY DEVELOP AN INCREASE IN LATERAL AND VERTICAL AXLE MOVEMENT. THIS MOVEMENT MAY CAUSE PART OR PARTS OF THE BRAKE ASSEMBLY (BRAKE CAM TUBE SUPPORT, BRAKE CHAMBER BRACKET, BRAKE CHAMBER, BRAKE SPIDER) TO DEVELOP FATIGUE CRACKS, POSSIBLY RESULTING IN THE FAILURE OF THE PART OR PARTS WITHIN THE BRAKE ASSEMBLY. Remedy: DEALERS WILL INSTALL THE CAM TUBE SUPPORT BRACKETS ON ALL OF THE REAR AXLE WHEEL ENDS. INSPECT THE REAR AXLE BRAKE ASSEMBLY AND REPLACE IT IF CRACKED. THE RECALL IS EXPECTED TO BEGIN DURING NOVEMBER 2008. OWNERS MAY CONTACT KENWORTH AT 1-425-828-5440.
KENWORTH IS RECALLING 3,423 MY 2004-2009 T2000, T800,T600, W900 AND T660 VEHICLES. INCREASED BRAKE EXCITATION IN A CERTAIN VEHICLE CONFIGURATION WHICH INCLUDES BENDIX DRUM BRAKES, WIDE BASE LOW PROFILE SINGLE TIRES, AND AN AG400 OR AG460 REAR SUSPENSION, DUE TO ITS UNIQUE BRAKE CLOCKING AND CAM TUBE LENGTH, CAN CAUSE FATIGUE AND CRACKING TO BRAKE ASSEMBLY COMPONENTS. Remedy: DEALERS WILL INSPECT THE REAR AXLE BRAKES ASSEMBLY, REPLACE CRACKED REAR AXLE BRAKES ASSEMBLY COMPONENTS WHERE REQUIRED, AND INSTALL CAM TUBE SUPPORT BRACKETS ON ALL REAR AXLE WHEEL ENDS FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN OR BEFORE JULY 25, 2009. OWNER MAY CONTACT KENWORTH AT 1-425-828-5440.
ON CERTAIN TRUCKS EQUIPPED WITH WEBASTO HEATERS, THE BURNER TUBES ARE MADE OF MATERIAL THAT DOES NOT MEET SPECIFICATIONS AND COULD FAIL PREMATURELY. Remedy: DEALERS WILL REPLACE THE SUSPECTED DEFECTIVE PARTS FREE OF CHARGE. THE RECALL BEGAN ON APRIL 4, 2004. OWNERS MAY CONTACT KENWORTH AT 425-828-5440 OR PETERBILT AT 940-591-4201.
ON CERTAIN TRUCKS, THE POWER FEED HARNESS P92-1993 TERMINALS WERE NOT PROPERLY CRIMPED. Remedy: DEALERS WILL REPLACE THE HARNESS. THE RECALL BEGAN JANUARY 13, 2005. OWNERS SHOULD CONTACT KENWORTH AT 1-425-828-5440.
ON CERTAIN TRACTORS EQUIPPED WITH CATERPILLAR DIESEL ENGINES, THE VARIABLE VALVE ACTUATION OIL LINE MAY WEAR AGAINST THE SHARP EDGE OF THE CYLINDER HEAD IF NOT POSITIONED CORRECTLY. Remedy: CATERPILLAR, IN CONJUNCTION WITH PACCAR, WILL BE CONDUCTING THE OWNER NOTIFICATION AND REMEDY FOR THIS CAMPAIGN FREE OF CHARGE. OWNERS MAY CALL CATERPILLAR AT 309-675-6496, KENWORTH AT 425-828-5440, OR PETERBILT AT 940-591-4201.
ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS, THE SUSPENSION HAS TRANSVERSE BEAM CASTINGS THAT MAY FRACTURE UNDER NORMAL LOADS. IF A CASTING BREAKS WHEN THE VEHICLE IS TRAVELING ON A ROADWAY THERE IS THE POTENTIAL FOR PIECES OF THE CASTING TO BECOME PROJECTILES AND THE SUSPENSION'S TRANSVERSE BEAM MAY DROP DOWN LOW ENOUGH TO CONTACT THE ROAD SURFACE. Remedy: DEALERS WILL INSPECT AND REPLACE THE DEFECTIVE TRANSVERSE BEAM ASSEMBLIES FREE OF CHARGE. THE RECALL BEGAN ON JUNE 10, 2005, WITH LETTERS BEING MAILED TO PETERBILT OWNERS; AND ON JUNE 17, 2005, FOR KENWORTH OWNERS. OWNERS MAY CONTACT PETERBILT AT 940-591-4201 OR KENWORTH AT 425-828-5440.
ON CERTAIN TRUCKS, THE WIRING, PARTS, OR TRANSMISSION PROGRAMMING REQUIRED FOR THE AUTO NEUTRAL FEATURE TO FUNCTION AS DESIGNED WERE EITHER NOT INSTALLED, CONNECTED, OR PROGRAMMED PROPERLY. Remedy: DEALERS WILL INSPECT THE AFFECTED VEHICLES TO ENSURE THE AUTO NEUTRAL FEATURE FUNCTIONS PROPERLY AND, IF NEEDED, WILL MAKE THE NECESSARY REPAIRS FREE OF CHARGE. THE RECALL BEGAN ON MAY 9, 2007. OWNERS MAY CONTACT KENWORTH AT 425-828-5440.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Certain vehicles may suffer cracking of various brake assembly components (i.e. brake cam tube mounting flanges, brake air chamber bracket, brake air chamber, brake spider). Over time, this cracking can cause a complete fracture of the cam tube, which could increase stopping distances and decrease parking brake hold capability. A reduction of braking capability could increase the risk of a crash causing property damage, personal injury or death. Correction: Dealers will inspect the rear axle brake assembly, replace cracked rear axle brake components where required, and install cam tube support brackets on all rear axle wheel ends.
On certain vehicles equipped with a Caterpillar C15 engine, the Variable Valve Actuation (VVA) oil line may wear against the P-clip retaining the oil line. An oil leak could result in a vehicle fire causing property damage and/or personal injury. Correction: Caterpillar dealers will replace the VVA oil line with an updated version.
Certain vehicle configuration which includes an AG400 rear suspension, long stroke brake chambers, and wide base tires may develop an increase in lateral and vertical axle movement. This movement may cause part or parts of the brake assembly to develop fatigue cracks, possibly resulting in the failure of part or parts within the brake assembly. A failure may reduce vehicle brake performance, increasing the risk of a crash causing personal injury or death. Correction: Dealers will affect repairs.
On certain trucks, the wiring, parts, or transmission programming required for the auto neutral feature to function as designed were either not installed, connected, or programmed properly. If any of these conditions exists, the transmission will not automatically shift into Neutral when left in Drive with the parking brake engaged. The vehicle could move without warning increasing the risk of a crash. Correction: Dealers will inspect and, if needed, make the necessary repairs.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles equipped with a Caterpillar engine, the Variable Valve Actuation oil line (VVA line) used on 6 cylinder, 15L turbocharged and air-to-air aftercooled diesel engines may wear against the sharp edge of the cylinder head if not oriented correctly. Oil line wear may cause an oil leak and a potential fire hazard. Correction: Dealers will inspect and, if required, replace the VVA line.
On certain vehicles, the rear suspension transverse beam castings were not made to specifications. If a casting were to break when the vehicle is in motion, parts could become projectiles with potential to cause property damage, personal injury or death. Also, the transverse beam may drop down low enough to contact the road surface causing sparks that could ignite a fire. Correction: Dealers will inspect and, if necessary, replace the transverse beams.
On certain vehicles, burner tubes in the Webasto DBW 2010 Scholastic coolant heater may begin deteriorating at an accelerated rate and could fail. Burner tube failure could result in an increase in exhaust gas temperature which could ignite combustible material in or around the vehicle. Correction: Dealers will replace the burner tubes.
On certain vehicles, the huck bolts used in the cab sub-assembly involving the door aperture and rear cab pillar was not properly installed. Under extreme loading conditions which could be encountered during an accident, that portion of the cab structure could be compromised. Correction: Dealers will inspect the cab and replace any loose huck bolts found.
On certain vehicles, the U-joint fasteners at the output yoke of the transmission were not properly torqued during assembly. If the U-joints were to become loose, a portion of the driveline could become detached from the vehicle and fall out from under the vehicle, which could cause a crash. Correction: Dealers will verify the torque and/or retorque each of the U-joint fasteners.
On certain vehicles, a potential chaffing point may exist between a heat shield on the engine and the wiring for the alternator. The interference is only present with the combination of a Caterpillar C11/C13 engine and the optional Leece Neville brushless alternator which is longer than any other alternators installed by Kenworth. Correction: Dealers will replace the alternator to a brush-type alternator that is shorter in length and provides the necessary clearance to all surrounding components.
Certain vehicles do not comply with the requirements of CMVSS 120. The vehicle tire pressure was omitted from the certification label. Correction: Dealers will install correct labels.