Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2004 Peterbilt 330, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
ON CERTAIN TRUCKS BUILT WITH CUMMINS ISC AND ISL ENGINES, PLUGS WERE ASSEMBLED INCORRECTLY CREATING STRESS AND CRACKS WHICH COULD CAUSE AN OIL LEAK. Remedy: CUMMINS WILL NOTIFY OWNERS AND ARRANGE FOR INSTALLATION OF A STEEL CUP PLUG BOSS CAP. OWNERS SHOULD CONTACT CUMMINS AT 1-800-343-7357.
ON CERTAIN TRUCKS EQUIPPED WITH CATERPILLAR C7 OR 3126E 2002 ENGINES AND HORTON FAN HUBS, THE FAN HUB MOUNTING BOLTS CAN FAIL RESULTING IN THE HUB AND FAN ASSEMBLY SEPARATING FROM THE ENGINE. THIS LOSS OF CLAMP LOAD CAUSES UNWANTED VIBRATION IN THE ASSEMBLY THAT LEADS TO BOLT FAILURE. Remedy: DEALERS WILL ADD A RIGID SPACER ACROSS THE TWO LOWER MOUNTING HOLES OF THE FAN HUB TO MAINTAIN THE CLAMPING FORCE AND REPLACE ALL THE BOLTS AND WASHERS. OWNER NOTIFICATION BEGAN OCTOBER 22, 2003. OWNERS SHOULD CONTACT PETERBILT AT 1-940-591-4201.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, the Cummins engines were assembled using a pneumatic tool to install the boss plug, in which the air pressure was set high enough to create stresses in the cylinder block casting. These stresses could eventually create open cracks in the cylinder block or result in less than adequate clamping pressure around the plug. When the plug loses it's clamping pressure, it will loosen from the cavity, causing an oil leak. This leakage of oil, near the exhaust manifold and turbocharger has the potential to ignite and cause a fire in the engine compartment. Correction: Cummins will install a steel cup plug boss cap which is attached over the boss/cup plug location with industrial sealant.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain