Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2004 Pierce Dash, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Pierce Manufacturing (Pierce) is recalling certain 2004-2018 Arrow XT, Dash, Enforcer, Impel, Quantum and Velocity aerial vehicles. The aerial device may unexpectedly rotate to the right when the ladder is being extended. Remedy: Pierce will notify owners, and dealers will reprogram the aerial control module, free of charge. The recall began February 28, 2019. Owners may contact Pierce customer service at 1-888-974-3723. Pierce's number for this recall is 74B295.
Pierce Manufacturing (Pierce) is recalling certain 1999-2013 Arrow XT, Dash, Enforcer, Quantum and Velocity fire trucks equipped with the electric All-steer rear steering option. The affected vehicles have rear steer axle shafts that were not properly heat treated. Remedy: Pierce will notify owners, and dealers will replace the rear steer axle shafts, free of charge. An interim notice was mailed on July 24, 2017. The recall began June 3, 2020. Owners may contact Pierce customer service at 1-888-974-3723.
PIERCE IS RECALLING CERTAIN MODEL YEAR 1999-2008 ARROW XT, DASH, LANCE, AND ENFORCER FIRE APPARATUS MANUFACTURED FROM JUNE 22, 1999, THROUGH MAY 12, 2008, AND EQUIPPED WITH AN ELECTRONIC ACCELERATOR PEDAL. AFTER REPEATED USE WITH EXCESSIVE FORCE, THE ACCELERATOR PEDAL ARM MAY BEND AND CAUSE THE PEDAL TO MOVE CLOSER TO THE FLOOR. IF THE PEDAL ARM BENDS FAR ENOUGH, THE PEDAL MAY CONTACT THE CAB FLOOR WITHOUT WARNING AND STICK IN THE FULL THROTTLE POSITION. Remedy: DEALERS WILL REMOVE THE EXISTING ACCELERATOR ARM AND INSTALL A REDESIGNED PEDAL ARM FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR ABOUT MAY 9, 2011. OWNERS MAY CONTACT PIERCE AT 1-920-832-3000.
PIERCE HAS DECIDED THAT CERTAIN MODEL YEAR 1995-2008 ARROW XT, DASH, CUSTOM CONTENDER, LANCE, ENFORCER, PIERCE ARROW, QUANTUM, SABER AND COMMERCIAL FIRE TRUCKS MANUFACTURED FROM JANUARY 2, 1995, THROUGH JANUARY 21, 2008, CONTAIN A SAFETY DEFECT. THESE VEHICLES ARE EQUIPPED WITH FUEL TANK STRAPS THAT MAY CORRODE DUE TO WINTER ROAD SALT OR LIQUID DE-ICING CHEMICALS. IF THE FUEL TANK STRAPS CORRODE SUFFICIENTLY, THE FUEL TANK SUPPORTING STRAPS MAY FRACTURE AND THE FUEL TANK MAY FALL FROM THE VEHICLE. Remedy: FOR FIRE TRUCKS THAT ARE LESS THAN 10 YEARS OLD, DEALERS WILL INSPECT THE FUEL TANK STRAPS AND REPLACE THEM IF NECESSARY WITH STAINLESS STEEL STRAPS FREE OF CHARGE. FOR VEHICLES THAT ARE OLDER THAN 10 YEARS, PIERCE IS NOT OFFERING A FREE REMEDY, BUT WILL OFFER FOR PURCHASE REPLACEMENT FUEL TANKS STRAPS AND PROVIDE INSTRUCTIONS FOR INSTALLATION. THE SAFETY RECALL BEGAN ON AUGUST 27, 2011. OWNERS MAY CONTACT PIERCE AT 1-920-832-3000.
Pierce Manufacturing Inc. (Pierce) is recalling certain model year 2000-2009 Enforcer and model year 2000-2010 Dash, Lance, and Arrow XT vehicles. While raising or lowering the cab as part of vehicle maintenance, the mounts on which the cab tilt cylinders pivot may fatigue and fail allowing the cab to fall until the safety catch activates. Remedy: Pierce will notify owners, and dealers will affix new safety signs advising the operator to stay clear of the cab while it is being tilted, free of charge. The recall began on January 6, 2014. Owners may contact Pierce at 1-920-832-3000. Pierce's recall number is 74B240.
PIERCE IS RECALLING CERTAIN MODEL YEAR 2003 THROUGH 2009 CUSTOM CONTENDER, DASH, ENFORCER, IMPEL, LANCE SABER, AND VELOCITY FIRE TRUCKS MANUFACTURED FROM FEBRUARY 20, 2003, THROUGH MARCH 27, 2009. THESE TRUCKS MAY BE EQUIPPED WITH DROP-DOWN FIRE HOSE TRAYS MOUNTED UNDER THE FRONT BUMPER. THE HOSE TRAY LATCH MAY ACCIDENTALLY OPEN WHILE THE VEHICLE IS IN MOTION. Remedy: A NEW AND IMPROVED LATCH DESIGN HAS BEEN DEVELOPED AND A NEW HOSE BOX INCORPORATING THE NEW LATCH WILL BE INSTALLED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON OCTOBER 4, 2010. OWNER MAY CONTACT PIERCE AT 1-920-832-3000.
PIERCE IS RECALLING CERTAIN MODEL YEAR 1998 THROUGH 2008 ARROW XT, LANCE, VELOCITY, ENFORCER, IMPEL, AND DASH CUSTOM FIRE APPARATUS VEHICLES MANUFACTURED FROM MAY 30, 1998 THROUGH NOVEMBER 25, 2008. THE STEERING GEAR BRACKET MAY FRACTURE AND BREAK. IF THIS OCCURS THE STEERING GEAR MAY DETACH FROM THE VEHICLE. Remedy: PIERCE WILL NOTIFY OWNERS AND DEALERS WILL INSTALL A NEW STEERING GEAR MOUNTING BRACKET FREE OF CHARGE. THE SAFETY RECALL BEGAN ON OCTOBER 12, 2010. OWNERS ARE BEING INSTRUCTED TO INSPECT THE STEERING GEAR BRACKET PRIOR TO EACH TRIP. THE REMEDY TO REPAIR THIS DEFECT IS EXPECTED TO BEGIN NO EARLIER THE JANUARY 31, 2011. OWNERS MAY CONTACT PIERCE AT 1-888-974-3723.
CERTAIN FIRE TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, 'SEATING SYSTEMS.' THE SEAT TETHER RESTRAINS THE SEAT DURING PULL TESTING AS THE SUSPENSION COMPONENTS ARE NOT DESIGNED TO RESTRAIN THE SEAT ON THEIR OWN. THE SUSPENSION SEAT TETHERS ARE TOO LONG. Remedy: DEALERS WILL REPLACE SUSPENSION SEAT TETHERS WITH SHORTER TETHERS. THE RECALL BEGAN ON APRIL 11, 2005. OWNERS MAY CONTACT PIERCE AT 1-888-974-3723.
ON CERTAIN FIRE TRUCKS, INTERFERENCE MAY OCCUR BETWEEN THE AERIAL FRONT AXLE INTERLOCK SENSOR BRACKET AND THE FRONT AIR BRAKE HOSE. THIS CONDITION OCCURS DURING FULL TURN STEERING AND FULL SUSPENSION JOUNCE COMPRESSION. Remedy: DEALERS WILL REMOVE THE EXISTING FRONT AXLE INTERLOCK SENSOR BRACKET AND INSTALL A NEW BRACKET IN A NEW LOCATION AVOIDING THE FRONT AXLE BRAKE HOSE. THE RECALL BEGAN ON OCTOBER 13, 2005. OWNERS MAY CONTACT PIERCE AT 920-832-3249.
CERTAIN FIRE TRUCKS WITH COMMAND CABS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207,"SEATING SYSTEMS." THE RESCUE BODY OFFERINGS DO NOT MEET THE PULL TEST REQUIREMENTS. THE PEDESTAL SEAT WAS MOUNTED BY DRILLING AND TAPPING THE CAB OR BODY FLOOR. Remedy: DEALERS WILL INSPECT THE SEAT PEDESTALS. IF THE SEAT WAS MOUNTED WITH TAPPED FASTENERS, THE FASTENERS WILL BE REMOVED AND A HOLE WILL BE DRILLED TO REPLACE THE MOUNTING FASTENERS WITH 7/16" BOLTS AND NUTS. THE RECALL BEGAN ON AUGUST 19, 2005. OWNERS MAY CONTACT PIERCE AT 920-832-3249.
CERTAIN FIRE TRUCKS EQUIPPED WITH HOLLAND/NEWAY AIR SUSPENSION SYSTEMS, A TRANSVERSE BEAM CASTINGS MAY FRACTURE UNDER NORMAL LOADS. IF A CASTING BREAKS WHEN THE VEHICLE IS TRAVELING ON A ROADWAY THERE IS THE POTENTIAL FOR PIECES OF THE CASTING TO BECOME PROJECTILES AND THE SUSPENSION?S TRANSVERSE BEAM MAY DROP DOWN LOW ENOUGH TO CONTACT THE ROAD SURFACE. Remedy: HOLLAND IS HANDLING THE OWNER NOTIFICATION AND REMEDY FOR THIS CAMPAIGN. DEALERS WILL INSPECT AND REPLACE THE DEFECTIVE TRANSVERSE BEAM ASSEMBLIES FREE OF CHARGE. OWNERS MAY CONTACT HOLLAND AT 616-396-6501 OR PIERCE AT 1-888-974-3723.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain trucks, the trunnion ears on the cab tilt cylinders pivot may fail while the cab is being raised or lowered for vehicle servicing or maintenance. This would allow the cab to drop until the safety flow velocity fuses engage and stop cab movement. A person in the path of the moving cab may be injured as a result. Correction: Dealers will install safety signs instructing operators to stand clear of cab while it is being tilted.
On certain fire trucks, after repeated use with excessive force, the accelerator pedal arm may bend and cause the foot pedal to move closer to the floor. If the pedal arm bends far enough, the foot pedal may contact the cab floor without warning and stick in the full throttle position. An accelerator pedal stuck at full throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could result in a loss of control and a crash causing property damage and/or personal injury. Correction: Dealers will replace the accelerator pedal arm with a redesigned version.
On certain fire trucks, the pitman arm may fracture under severe load caused by three loading conditions. In all cases, the front axle must be turned full left or right while: 1) simultaneously backing-up and braking hard, 2) driving one wheel over or against a curb, or, 3) steering the front axle full left or right when the vehicle is stationary. These are all low or no-speed events. Correction: Dealers will install pitman arms made of higher strength material.
On certain fire trucks, the suspension seat restraining tethers are too long to ensure compliance with CMVSS 207. The seat tether restrains the seat during pull testing as the suspension components are not designed to restrain the seat on their own. The longer seat tethers may not adequately restrain the seat during a vehicle crash, increasing the risk of injury to the occupant. Correction: Dealers will replace the seat tethers with shorter ones.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
On certain fire trucks, interference may occur between the aerial front axle interlock sensor bracket and the front air brake hose. This condition occurs during full turn steering and full suspension jounce (compression). This interference may cause chaffing leading to a potential front air brake hose failure. In the event of a front brake hose failure, loss of front braking will occur, increasing the risk of a crash. Correction: Dealers will remove the existing front axle interlock sensor bracket and install a new bracket in a new location avoiding the front axle brake hose. Note: Further evaluation revealed that only U.S. vehicles are affected.