Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2005 GMC Sierra, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH AN AUTOMATIC TRANSMISSION, FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 102, "TRANSMISSION SHIFT LEVER SEQUENCE, STARTER INTERLOCK AND TRANSMISSION BRAKING EFFECT." UNDER CERTAIN VEHICLE STARTING CONDITIONS, THE SHIFT LEVER POSITION INDICATOR LOCATED IN THE INSTRUMENT PANEL CLUSTER MAY NOT ILLUMINATE. IF THE SHIFT LEVER POSITION INDICATOR DOES NOT ILLUMINATE, THE DRIVER MAY NOT KNOW WHICH GEAR THE VEHICLE IS IN. Remedy: DEALERS WILL REPROGRAM THE INSTRUMENT PANEL CLUSTER FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 14, 2005. OWNERS MAY CONTACT CADILLAC AT 1-866-982-2339, CHEVROLET AT 1-800-630-2438, AND GMC AT 1-866-996-9463.
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.
ON CERTAIN TRUCKS EQUIPPED WITH AN 8.1L V8 (RPO L8-VIN G) ENGINE HAVE A CONDITION IN WHICH THE ENGINE FUEL RAIL PULSE DAMPER RETAINER CLIP MAY FRACTURE RESULTING IN INADEQUATE RETENTION OF THE DAMPER. Remedy: DEALERS WILL REPLACE THE ENGINE FUEL RAIL PULSE DAMPER RETAINER CLIP FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 31, 2006. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438 AND GMC TRUCKS AT 1-866-996-9463.
ON CERTAIN SPORT UTILITY VEHICLES AND PICKUP TRUCKS EQUIPPED WITH 5.3L (RPO L59) V8 ENGINES, THE ENGINE FUEL RAIL CROSSOVER TUBE RETAINER SCREWS WERE NOT MANUFACTURED TO SPECIFICATIONS AND MAY BREAK. Remedy: DEALERS WILL INSPECT THE FUEL RAIL CROSSOVER TUBE AND, IF NECESSARY, REPLACE THE RETAINER SCREWS. OWNERS WERE NOTIFIED BY TELEPHONE ON JULY 30, 2004, WITH A FOLLOWUP OWNER LETTER BEGAN AUGUST 5, 2004. OWNERS SHOULD CONTACT CHEVROLET AT 1-800-630-2438 OR GMC AT 1-866-996-9463. NOTE: THE GM BULLETIN LISTS THE TAHOE AND YUKON MODELS BECAUSE CANADIAN VEHICLES ARE INCLUDED IN THE BULLETIN. NO U.S. TAHOE OR YUKON VEHICLES ARE INCLUDED IN THE U.S. CAMPAIGN.
ON CERTAIN CREW CAB PICKUP TRUCKS AND SPORT UTILITY VEHICLES, THE 2ND ROW CENTER OCCUPANT SEAT BELT ROUTING MAY MAKE IT DIFFICULT TO POSITION THE LAP PORTION OF THE SAFETY BELT LOW AROUND THE HIPS OF OCCUPANTS, ESPECIALLY SMALLER OCCUPANTS, SEATED IN THIS POSITION. APPROPRIATE USE OF A CHILD SEAT OR BOOSTER SEAT, AS RECOMMENDED FOR SMALL CHILDREN, DOES IMPROVE THE FIT CONDITION FOR THIS USER GROUP. IN ADDITION TO INSTRUCTIONS ON PROPER INFANT AND YOUNG CHILD RESTRAINT (WITH CHILD SEATS OR BOOSTERS), SPECIAL VERBIAGE FOR RESTRAINING OLDER CHILD IS INCLUDED IN THE OWNER'S MANUAL. ALSO, THE SUGGESTED SEAT BELT FIT/ROUTING FOR ADULTS, IRRESPECTIVE OF SEATING POSITION, IS DESCRIBED IN THE OWNER'S MANUAL TEXT. Remedy: DEALERS WILL CUT OPEN THE GUIDE LOOP, REMOVE A PORTION OF THE LOOP, AND THEN THE REMAINING TWO SIDES SHOULD BE FOLDED OVER AND SECURED WITH A RETAINER FREE OF CHARGE. THE RECALL BEGAN ON JULY 21, 2005. OWNERS MAY CONTACT CADILLAC AT 1-866-982-2339, CHEVROLET AT 1-800-630-2438, GMC AT 1-866-996-9463, OR HUMMER AT 1-800-732-5493.
CERTAIN PASSENGER VEHICLES MAY HAVE BEEN BUILT WITH A POWER STEERING HOSE THAT IS NOT TO SPECIFICATION. UNDER EXTREME STEERING MANEUVERS, SUCH AS TURNING THE STEERING WHEEL FULLY TO THE LEFT OR RIGHT WHILE BRAKING, THE HOSE MAY FRACTURE AND LEAK FLUID. Remedy: DEALERS WILL INSPECT THE POWER STEERING HOSE(S) FOR TWO SUSPECT DATE CODES AND REPLACE THEM IF REQUIRED. THE RECALL WILL BEGIN ON OCTOBER 14, 2005. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438, GMC AT 1-866-996-9463, BUICK AT 1-866-608-8080, CADILLAC AT 1-866-982-2339, ISUZU AT 1-800-255-6727, OR HUMMER AT 1-800-732-5493.
CERTAIN CEQUENT 90 DEGREE 7-WAY RIGHT ANGLE ADAPTORS SOLD BY DISTRIBUTORS IN TOW PACKAGES FOR AFTERMARKET SALES TO TOW 5TH WHEEL RV TRAVEL TRAILERS. DUE TO INCORRECT WIRING OF THE HARNESS, THE TRAILER LIGHTS MAY NOT OPERATE PROPERLY. Remedy: ALL OF THE DEFECTIVE TOW PACKAGES ARE STILL AT THE DISTRIBUTOR LEVEL AND HAVE NOT BEEN SOLD TO ANY CONSUMERS.
CERTAIN VEHICLES ORIGINALLY BUILT WITH CLOTH SEATS THAT WERE EQUIPPED WITH AN AUTOMATIC AIR BAG PASSENGER SENSING SYSTEM AND LATER REUPHOLSTERED WITH AFTERMARKET LEATHER SEAT COVER KITS ARE INVOLVED. TESTING HAS INDICATED THAT THE AFTERMARKET LEATHER SEAT COVERS CAN CAUSE THE PASSENGER SENSING SYSTEM TO MALFUNCTION. Remedy: BECAUSE A REPLACEMENT LEATHER SEAT COVER THAT IS COMPATIBLE WITH THE PASSENGER SENSING SYSTEM IS NOT AVAILABLE, GENERAL MOTORS (GM) WILL REPURCHASE THESE VEHICLES IN ACCORDANCE WITH THE TERMS STATED IN GM'S LETTER TO OWNERS. THE RECALL BEGAN ON NOVEMBER 6, 2006. OWNERS SHOULD CONTACT GM AT 1-877-477-1022 TO BEGIN THE PROCESS OF REPURCHASING THEIR VEHICLE.
ON CERTAIN PICKUP TRUCKS EQUIPPED WITH MANUAL TRANSMISSIONS AND BUILT WITH EITHER PBR PARKING BRAKE SYSTEMS OR TRW PARKING BRAKE SYSTEMS, THE PARKING BRAKE FRICTION LININGS MAY WEAR TO AN EXTENT WHERE THE PARKING BRAKE CAN BECOME INEFFECTIVE IN IMMOBILIZING A PARKED VEHICLE. Remedy: DEALERS WILL INSTALL A LOW-FORCE SPRING CLIP RETAINER FOR VEHICLES EQUIPPED WITH A PBR PARKING BRAKE SYSTEM. ON VEHICLES EQUIPPED WITH THE TRW PARKING BRAKE SYSTEM, DEALERS WILL INSTALL A REDESIGNED PARKING BRAKE CABLE ASSEMBLY. THE RECALL BEGAN ON JULY 29, 2005. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438 OR GMC AT 1-866-996-9463.
ON CERTAIN TRUCKS, THE BOLT THAT ATTACHES THE INTERMEDIATE STEERING SHAFT TO THE STEERING GEAR MAY NOT MEET SPECIFICATION. THE BOLT MAY FRACTURE RESULTING IN THE LOSS OF STEERING. Remedy: DEALERS WILL REPLACE THE INTERMEDIATE STEERING SHAFT BOLT FREE OF CHARGE. THE RECALL BEGAN ON JANUARY 24, 2005. OWNERS MAY CONTACT GMC AT 1-866-996-9463 AND CHEVROLET AT 1-800-630-2438.
CERTAIN TRUCKS, SPORT UTILITY VEHICLES, AND VANS EQUIPPED WITH BOSCH HYDRO-BOOST BRAKE ASSEMBLIES, THE HYDRAULIC BRAKE BOOSTER PRESSURE ACCUMULATOR MAY CRACK AND SEPARATE FROM THE HYDRO-BOOST ASSEMBLY DURING NORMAL OPERATING CONDITIONS. Remedy: DEALERS WILL TEST THE HYDRO-BOOST ASSEMBLY FOR FUNCTIONAL OPERATION OF THE TWO-FUNCTION VALVE. IF THE HYDRO-BOOST ASSEMBLY FAILS THE TEST, DEALERS WILL REPLACE THE ASSEMBLY FREE OF CHARGE. THE RECALL BEGAN ON MARCH 23, 2005. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438, GMC TRUCKS AT 1-866-996-9463 AND HUMMER AT 1-800-732-5493.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
*** This notice is provided for information purposes only as the subject equipment is not regulated under the Motor Vehicle Safety Act *** A safety defect may exist in aftermarket ACDelco brake shoes manufactured between April 1st 2013 to April 19 2014, sold and/or installed as service replacement parts. The lining of the rear brake shoe may detach from the steel shoe during normal service, causing the affected brake to fail. If the lining detaches from the steel shoe, it could cause rear-wheel lockup and it will reduce the available braking force which could lengthen the required stopping distance, and increase the risk of a crash without prior warning. Correction: GM Dealers, ACDelco warehouse distributors and their professional installer customers are to inspect the manufacture date of the rear brake shoes and, if necessary, replace the shoes. Customers of the 125 vehicles that were serviced by GM Dealers with the suspect parts will be notified by first class letter.
On certain vehicles, the interface between the electrical terminals of the Heating, Ventilation, and Air Conditioning (HVAC) blower relay resistor module and the wiring connector (which powers the module) may be incapable of conducting higher current levels for sustained periods of operation. In addition, moisture and other contaminants (such as road de-icing materials) may enter the fresh air intake plenum and contact the internal circuit of the module or corrode the terminals. These conditions may cause the relay resistor module or wiring connector to overheat, causing various symptoms such as: the HVAC blower may not function on certain or all blower speed settings; a burning-plastic smell or smoke may be present in the vehicle, or; the HVAC blower may run continually with the ignition in the OFF position. These warning signs could, in certain instances, be leading indicators of an impending vehicle fire, which could result in property damage and/or personal injury. Correction: Owners will be provided with additional warranty coverage for the blower motor resistor module/wiring connector overheating condition. Under this "special warranty coverage", should this condition occur within 10 years or 240,000 km from first vehicle registration, dealers will install a replacement blower motor resistor and resistor module connector.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, the engine fuel rail pulse damper retainer clip may fracture, resulting in inadequate retention of the damper. If the damper comes loose, a fuel leak may result. Fuel leakage in the presence of an ignition source could result in a fire. Correction: Dealers will replace the engine fuel rail pulse damper retainer clip.
Certain vehicles may have been built with a power steering hose that is not to specification. Under extreme steering manoeuvres, such as turning the steering wheel fully to the left or right while braking, the hose may fracture and leak fluid. If this were to occur, power steering assist would be lost and increased steering effort would be required. On vehicles equipped with hydro-boost power brakes, it could also result in loss of power brake assist and increase braking effort would be required. If power steering fluid were to spray onto hot engine parts, an engine compartment fire could occur. Correction: Dealers will inspect the power steering hose(s) for two suspect date codes and replace them if required.
On certain vehicles, the 2nd row centre occupant seat belt routing may make it difficult to position the lap portion of the safety belt low around the hips of occupants. A lap portion of the seat belt routing that is not low and snug on the hips can allow unfavourable occupant kinetics in the event of a crash. Moreover, the higher routing allows the lap belt to ride up on an occupant's abdomen instead of fitting low around their hipbones, and therefore, can expose them to more risk of abdominal and internal organ injury. Correction: Dealers will modify the guide loop.
On certain 1999-2002 1500 series and 2001-2005 2500 & 3500 series trucks equipped with a manual transmission, the parking brake friction lining may wear to an extent where the parking brake can become ineffective in immobilizing a parked vehicle. Correction: Dealers will install a low-force spring clip retainer on vehicles equipped with PBR parking brake system and install a redesigned parking brake cable assembly on vehicle equipped with a TRW parking brake system.
Certain Sierra Denali vehicles do not comply with the requirements of CMVSS 210.2 pertaining to location and instructions for properly attaching child restraints. The owner's manual indicates the incorrect seat locations of the upper and lower tether anchors, and provides incorrect installation instructions for the top tether anchorage. Correction: An owner's manual update, describing the location and proper use of the tethers anchors, will be mailed to owners.
On certain vehicles, the hydraulic brake booster's pressure accumulator may crack and/or separate from the Hydro-Boost assembly during normal vehicle operating conditions. If a separation occurred and the hood of the vehicle was open, fragments from the accumulator could cause injury to people in the immediate area. In addition, the presence of this crack or fractured surface could allow the hydraulic fluid to leak from the accumulator circuit of the booster assembly. The loss of fluid would cause increased steering and braking effort. Correction: Dealers will test and, if necessary, replace the Hydro-Boost assembly.
Certain vehicles equipped with an automatic transmission fail to comply with the requirements of CMVSS 101 - Location, identification and illumination of displays. Under certain vehicle starting conditions, the shift lever position indicator located in the instrument panel cluster may not illuminate. In subsequent vehicle start-ups, this condition may or may not occur again. If the shift lever position indicator does not illuminate, the driver may not know which gear the vehicle is in and the vehicle may move in an unintended direction, resulting in possible injury to others outside of the vehicle. Correction: Dealers will reprogram the instrument panel cluster.
On certain vehicles, the bolt that attaches the intermediate steering shaft to the steering gear may fracture resulting in the loss of steering control. If this happens while the vehicle is moving, a crash could occur without prior warning. Correction: Dealers will replace the intermediate steering shaft to steering gear bolt.
On certain vehicles, the fuel rail crossover tube retainer screws were not manufactured to specifications and may break. If a tube retainer screw breaks, fuel could leak from the fuel rail crossover joint, the engine may stall and, if an ignition source were present, an engine compartment fire could occur. Correction: Dealers will inspect the fuel rail crossover tube assembly and, if necessary, replace the two tube retainer screws.