Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2005 Jeep Grand Cherokee, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
This defect can affect the safe operation of the airbag system. Until this recall is performed, drivers should adjust their seat to allow clearance between the driver's knee and the ignition key, and remove all items from their key ring, leaving only the vehicle key. Chrysler Group LLC (Chrysler) is recalling certain model year 2005-2007 Jeep Grand Cherokee vehicles manufactured February 11, 2004, to July 5, 2007, and 2006-2007 Jeep Commander vehicles manufactured January 31, 2005, to July 5, 2007. In the affected vehicles, the driver may accidentally hit the ignition key with their knee, unintentionally knocking the key out of the run position, turning off the engine. Remedy: Chrysler will notify owners, and dealers will replace the ignition switch, free of charge. Chrysler sent interim notifications to owners in September 2014. The recall began on October 9, 2015. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is P41.
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS. Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
Chrysler Group LLC (Chrysler) is recalling certain model year 2005-2010 Jeep Grand Cherokee vehicles manufactured February 11, 2004, through March 9, 2010; and 2006-2010 Jeep Commander vehicles manufactured January 31, 2005, through March 10, 2010. A transfer case electrical failure may result in an unintentional shifting of the transfer case into the neutral position. Remedy: Chrysler will notify owners, and dealers will reflash the final drive controller which governs the transfer case, with new software, free of charge. The recall began on August 15, 2013. Owners may contact Chrysler at 1-800-247-9753. Chrysler's recall campaign number is N23.
ROCK KRAWLER IS RECALLING 44 PERFORMANCE SUSPENSION SYSTEMS SOLD AS AFTERMARKET EQUIPMENT FOR USE ON THE VEHICLE LISTED ABOVE. THESE SUSPENSION SYSTEMS WERE PRODUCED WITH GRADE 2 CARRIAGE BOLTS INSTEAD OF THE PROPER GRADE 5 CARRIAGE BOLTS. THE IMPROPER GRADE 2 CARRIAGE BOLTS COULD EXPERIENCE A LOSS OF CLAMPING FORCE FOR THE BOTTOM STRUT FORK. Remedy: ROCK KRAWLER WILL NOTIFY OWNERS AND PROVIDE A FREE REMEDY. THE SAFETY RECALL BEGAN ON OCTOBER 15. 2008. ALL THE AFFECTED UNTITS HAVE BEEN REMEDIED. OWNERS MAY CONTACT ROCK KRAWLER AT 1-518-270-9822.
ON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH 3.7L ENGINES AND NAG1 AUTOMATIC TRANSMISSIONS, THE AIR CONDITIONER EVAPORATOR CONDENSATE WATER MAY ENTER THE TRANSMISSION AT THE FILL TUBE GROMMET SEAL. THIS CAN RESULT IN SHUDDER DURING TORQUE CONVERTER CLUTCH ENGAGEMENT. Remedy: DEALERS WILL INSPECT THE TRANSMISSION FOR LEAKAGE AT THE FILL TUBE GROMMET SEAL. IF NO LEAK IS DETECTED, A NEW FILL TUBE GROMMET SEAL AND WATER DEFLECTOR SHIELD WILL BE INSTALLED, AND PROPER ALIGNMENT OF THE FILL TUBE VERIFIED. IF THE PRESENCE OF A LEAK IS DETECTED, THE VEHICLE WILL BE EVALUATED FOR SHUDDER DURING TORQUE CONVERTER ENGAGEMENT. IF NO SHUDDER IS DETECTED, THE TRANSMISSION WILL BE TRIPLE FLUSHED, AND NEW FILL TUBE GROMMET SEAL AND WATER DEFLECTOR WILL BE INSTALLED AND PROPER ALIGNMENT OF THE FILL TUBE VERIFIED. IF SHUDDER IS DETECTED, THE TORQUE CONVERTER WILL BE REPLACED, A NEW FILL TUBE GROMMET SEAL AND WATER DEFLECTOR WILL BE INSTALLED, AND PROPER ALIGNMENT OF THE FILL TUBE VERIFIED. THE RECALL BEGAN ON OCTOBER 31, 2005. OWNERS MAY CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, a defect in the ignition switch could allow the switch to move out of the "run" position if the key ring is carrying added weight or the driver unintentionally bumps the ignition key with their knee. An unintended change in ignition switch position while driving may result in loss of engine power, power steering, and braking assist, increasing the risk of a crash and disabling one or more of the vehicle’s safety features including the frontal airbags. Correction: Dealers will replace the ignition switch and lock cylinder. Important note: Until the correction is performed, drivers should adjust their seat to allow clearance between their knee and the ignition key, and remove all items from the key ring.
On certain vehicles equipped with a full-time four-wheel drive system, the transfer case controller could fail. This could cause the transfer case to shift into or through the neutral position, which may allow the vehicle to roll away, even with the transmission in the PARK position. Should the vehicle roll away, it could strike another vehicle, stationary object, or a bystander, causing property damage and/or personal injury. Correction: Dealers will reprogram the final drive controller with updated software.
On certain vehicles equipped with a 3.7L engine and automatic transmission, water from the air conditioner evaporator drain tube may enter the transmission at the fill tube grommet seal. This can result in shudder during torque converter clutch engagement which, if ignored by the operator, could lead to increased transmission operating temperatures, boiling of the water, and a subsequent purging of transmission fluid into the engine compartment that could lead to a fire. Correction: Dealers will inspect the transmission for leakage at the fill tube grommet seal. If no leak is detected, a new fill tube grommet seal and water deflector shield will be installed, and proper alignment of the fill tube verified. If the presence of a leak is detected, the vehicle will be evaluated for a shudder condition and based on the evaluation, the transmission will either be triple flushed or the torque converter replaced as required and a new grommet seal and water deflector will be installed.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain