Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2005 Saab 9-7X, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
General Motors LLC (GM) is recalling certain model year 2005-2007 SAAB 9-7x; 2006 Chevrolet Trailblazer EXT and GMC Envoy XL; and 2006-2007 Chevrolet Trailblazer, GMC Envoy, Buick Rainier and Isuzu Ascender vehicles. Fluid may enter the driver's door master power window switch module, causing corrosion that could result in a short in the circuit board. A short may cause the power door lock and power window switches to function intermittently or become inoperative. The short may also cause overheating, which could melt components of the door module, producing odor, smoke, or a fire. Remedy: GM will notify owners, and dealers will inspect the part number on the door module, and install a new door module if necessary, free of charge. Parts for the remedy are not currently available. An interim letter was mailed to owners in August 2014. A second owner letter will be mailed when parts are available. Owners may contact GM customer service at 1-800-521-7300 (Buick), 1-800-222-1020 (Chevrolet), 1-800-462-8782 (GMC), 1-800-955-9007 (SAAB), and 1-800-255-6727 (Isuzu). GM's number for this recall is 14309. NOTE: This recall provides a new remedy for all vehicles covered by recall 13V-248. Vehicles whose modules were modified but not replaced as part of the previous recall remedy must have their vehicles remedied again under this campaign.
General Motors (GM) is recalling certain model year 2005-2007 SAAB 9-7x; 2006 Chevrolet Trailblazer EXT and GMC Envoy XL; and 2006-2007 Chevrolet Trailblazer, GMC Envoy, Buick Rainier and Isuzu Ascender vehicles. Fluid may enter the driver's door module, causing corrosion that could result in a short in the circuit board. A short may cause the power door lock and power window switches to function intermittently or become inoperative. The short may also cause overheating, which could melt components of the door module, producing odor, smoke, or a fire. Remedy: Owners will be contacted and dealers will test the driver's door module. If the module is functioning properly, a protective coating will be applied. If the module is not functioning properly, it will be replaced. These repairs will be done free of charge. GM will notify Buick, Chevrolet, and GMC owners, Isuzu and Saab will contact their respective owners. The recall began on August 2, 2013. Buick owners may contact the owner center at 1-800-521-7300, Chevrolet owners at 1-866-694-6546, GMC owners at 1-866-996-9463, Isuzu owners at 1-800-255-6727, and Saab owners at 1-800-955-9007. GM's campaign number is 12180. This recall is an expansion of recall 12V-406.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act. Safety Risk: Glass that breaks in to large pieces could create a risk of injury. Corrective Actions: The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.
On certain vehicles, the driver’s door module could experience electrical faults resulting a loss of switch function, erratic switch behaviour (such as power windows lowering and/or raising without driver input) or an electrical short circuit, potentially resulting in a vehicle fire. These issues could occur even when the ignition key is removed and could increase the risk of injury and/or property damage. Correction: Dealers will inspect the driver’s door module part number and replace if necessary. In the interim, owners should park their vehicle outdoors. Note: This recall supersedes recalls 2012-282 and 2013-210. Vehicles that were inspected and/or repaired under the previous recalls will require re-inspection and/or repair.
On certain vehicles, the driver’s door module could short circuit and fail. An electrical short could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will test the driver’s window and door lock switches for proper operation. If the switches function correctly, a protective coating will be applied to the door module. If the switches do not function properly, the door module will be replaced. Note: This recall affects vehicles not covered by 2012-282 due to their geographic location.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles originally sold in or currently operated in areas of heavy road salt usage during winter months (Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundland & Labrador), the driver’s door module could short circuit and fail. An electrical short could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will test the driver’s window and door lock switches for proper operation. If the switches function correctly, a protective coating will be applied to the door module. If the switches do not function properly, the door module will be replaced.