Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2006 BIG DOG K-9, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
ON CERTAIN MOTORCYCLES, THE ELECTRONIC HARNESS CONTROL (EHC) MODULE CAN FAIL RESULTING IN A TOTAL SHUT DOWN OF THE VEHICLE'S ELECTRONIC POWER. Remedy: DEALERS WILL REPLACE THE EHC MODULES FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 19, 2006. OWNERS MAY CONTACT BIG DOG AT 316-267-9121.
ON CERTAIN MOTORCYCLES, A WARPED BUS BAR WITHIN THE VOLTAGE REGULATOR CAN CAUSE A SHORT CIRCUIT. Remedy: DEALERS WILL REPLACE THE EXISTING CIRCUIT BREAKER LOCATED BETWEEN THE VOLTAGE REGULATOR POSITIVE BATTERY LEAD (B+ LEAD) AND THE POSITIVE BATTERY TERMINAL WITH AN ALTERNATIVE CIRCUIT PROTECTION DEVICE THAT WILL PREVENT A THERMAL EVENT IF THERE IS A SHORT TO GROUND. THE RECALL BEGAN ON OCTOBER 1, 2007. OWNERS MAY CONTACT BIG DOG AT 1-316-219-9129 OR EMAIL TO CUSTOMER.SERVICE@BIGDOGMOTORCYCLES.COM.
CERTAIN BIG DOG AFTERMARKET SISSY BAR ASSEMBLIES SOLD AS AN ACCESSORY PART FOR THE MOTORCYCLES LISTED ABOVE. THE SISSY BAR ASSEMBLIES MAY BE UNDERSIZED, ALLOWING EXCESSIVE MOVEMENT OF THE SISSY BAR. OVER TIME, THIS COULD CAUSE THE BOLTS THAT RETAIN THE SISSY BAR TO BREAK ALLOWING THE SISSY BAR TO DETACH FROM THE MOTORCYCLE. Remedy: BIG DOG WILL NOTIFY OWNERS AND REPLACE THE AFFECTED SISSY BARS FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN ON OR ABOUT AUGUST 24, 2007. OWNERS CAN CONTACT BIG DOG MOTORCYCLES CUSTOMER SERVICE DEPARTMENT COLLECT AT 316-267-9121.
ON CERTAIN MOTORCYCLES, THE KICKSTAND SPRING MAY STRETCH AND DETACH FROM THE MOUNTING BRACKET OR THE KICKSTAND. Remedy: DEALERS WILL INSTALL A NEW KICKSTAND SPRING FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 17, 2006. OWNERS MAY CONTACT BIG DOG AT 316-267-9121.
ON CERTAIN MOTORCYCLES, THE REAR FENDER STRUT ATTACHING BOLTS CAN FAIL ALLOWING THE REAR FENDER TO DETACH FROM THE MOTORCYCLE. Remedy: DEALERS WILL REMOVE EXISTING STRUT BOLTS AND REPLACE WITH HIGHER TENSILE STRENGTH ATTACHING BOLTS AND UPDATED WASHERS. HIGHER TORQUE VALUES WILL BE OBSERVED WHEN INSTALLING THE REPLACEMENT FASTENERS. THE RECALL BEGAN ON JANUARY 21, 2008. OWNERS MAY CONTACT BIG DOG AT 316-267-9121.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain