Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2006 BMW 6 Series, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
BMW IS RECALLING CERTAIN MODEL YEAR 2004-2010 5-SERIES, MODEL YEAR 2004-2010 6-SERIES, MODEL YEAR 2006-2010 M5, AND MODEL YEAR 2007-2010 M6 VEHICLES. THE INSULATED BULKHEAD CONNECTOR FOR THE POSITIVE BATTERY CABLE MAY HAVE BEEN INCORRECTLY ATTACHED TO THE TRUNK FLOOR PANEL, WHICH CAN LEAD TO A LOOSENING OF THE BOLT CONNECTION. AS IT LOOSENS, AN INCREASE IN ELECTRICAL RESISTANCE AT THIS CABLE CONNECTION IS POSSIBLE AND COULD CAUSE THE CABLE CONNECTION TO OVERHEAT. Remedy: BMW WILL NOTIFY OWNERS, AND DEALERS WILL INSPECT AND SECURE THE BATTERY BOLT CABLE CONNECTION AS NECESSARY, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON APRIL 30, 2012. OWNERS MAY CONTACT BMW CUSTOMER RELATIONS AND SERVICES AT 1-800-525-7417.
BMW IS RECALLING CERTAIN MODEL YEAR 2004-2010 5-SERIES, 6-SERIES, AND MODEL YEAR 2002-2008 7-SERIES VEHICLES. A CHECK VALVE OF THE BRAKE VACUUM PUMP MAY LEAK A SMALL AMOUNT OF LUBRICATING OIL. OVER TIME THIS COULD RESULT IN CONTAMINATION OF THE BRAKE BOOSTER. Remedy: BMW WILL NOTIFY OWNERS AND DEALERS WILL REPAIR THE VEHICLES FREE OF CHARGE. THE SAFETY RECALL BEGAN ON NOVEMBER 24, 2010. OWNERS MAY CONTACT BMW AT 1-800-525-7417.
ON CERTAIN PASSENGER VEHICLES, THE LOWER RUBBER MOUNT OF THE REAR SHOCK ABSORBERS MAY NOT HAVE BEEN MANUFACTURED TO SPECIFICATIONS AND MAY NOT ADHERE CORRECTLY TO ITS HOUSING WITHIN THE SHOCK ABSORBER. Remedy: DEALERS WILL REPLACE THE REAR SHOCK ABSORBER FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 13, 2006. OWNERS MAY CONTACT BMW AT 1-800-831-1117.
CERTAIN PASSENGER VEHICLES MAY HAVE BEEN BUILT WITH AN INCORRECTLY MANUFACTURED AUTOMATIC TRANSMISSION PARKING PAWL GUIDE PLATE. Remedy: DEALERS WILL REPAIR AND REPLACE THE AUTOMATIC TRANSMISSION GUIDE PLATE FREE OF CHARGE. THE RECALL BEGAN ON NOVEMBER 30, 2005. OWNERS MAY CONTACT BMW AT 1-800-332-4269.
ON CERTAIN PASSENGER VEHICLES, THE NUTS WHICH SECURE THE FRONT AXLE CONTROL ARM AND TENSION STRUT TO THE FRONT WHEEL HUB MAY NOT HAVE BEEN TIGHTENED TO SPECIFICATION. OVER TIME THE NUTS COULD LOOSEN AND THE CONTROL ARM AND TENSION STRUT COULD BE DAMAGED. Remedy: DEALERS WILL RETIGHTEN THE FRONT AXLE CONTROL ARM AND TENSION STRUT NUTS TO THE CORRECT SPECIFICATIONS FREE OF CHARGE. THE RECALL BEGAN ON JUNE 28, 2006. OWNERS MAY CONTACT BMW AT 1-800-831-1117.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, the front passenger seat occupant detection mat can fatigue over time. As a result, the passenger airbag could deactivate, illuminating the airbag warning lamp and the passenger airbag ON/OFF lamp. Failure of the passenger airbag to deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Correction: Vehicles will receive special extended warranty coverage of 10 years from first registration. Under this special coverage program, vehicles which experience this condition will have the occupant detection mat replaced.
On certain vehicles, the insulated bulkhead connector (used to join the two halves of the positive battery cable) may have been incorrectly installed during vehicle assembly. Over time, the bolt connection could loosen, which would increase electrical resistance. In addition, an incorrectly insulated bulkhead connector could allow humidity to accumulate at this location, causing current leakage. These issues could cause the cable connection to overheat, which could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will inspect and, as necessary, secure the insulated bulkhead connector. In addition, protective grease will be added to the area and the plastic battery positive terminal cover will be replaced.
On certain vehicles, a check valve in the brake vacuum pump may leak a small amount of lubricating oil. Over time, this could result in contamination of the brake booster. Loss of brake power assist could occur which, in conjunction with traffic, road conditions, and driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the brake booster and master cylinder. Additionally, the brake vacuum line (including the check valve) will be replaced to eliminate the possibility of oil reaching the brake booster.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, the front passenger seat occupant detection mat can fatigue during field usage depending on the seat configuration, vehicle geometry, manner and frequency of front passenger entry/exit. Over time micro cracks could develop in the side flanks of the mat, which could lead to a break of the conductive path and the system will recognize a failure and with exception of head protection system the front passenger air bag will be deactivated. The airbag On/Off lamp will be illuminated to make the occupants aware of the deactivation. Correction: The occupant detection mat will be granted a warranty extension of 10 years.
Certain 550I, 650I cabriolet, 650I coupe, and X5 vehicles equipped with a V8 engine, operated in conditions of below-freezing temperatures combined with low humidity, may suffer an electrostatic discharge at the fuel rails. If this were to occur, the engine's Electronic Control Unit (ECU) could be affected such that engine stalling could result. If the engine were to stall, this would result in a loss of power steering. Loss of power steering could lead to a condition in which vehicle handling and control were impaired. Correction: Dealers will install two additional ground cable between the fuel rails and the ground connection of the ignition coils.
On certain vehicles, the rear shock lower bushings may not have been manufactured to specification (improper vulcanization of the bushing). Depending on vehicle operation and temperature conditions, this could lead to a loosening of the bushing within its housing. Over time, the bushing could continue to loosen and may eventually separate from its housing. Correction: Dealers will replace the rear strut assemblies.
On certain vehicles, the guide plate of the automatic transmission's parking lock pawl subsystem may fail. This could cause the parking lock pawl not to engage, after placing the transmission in the PARK position. If the vehicle was parked on an incline of sufficient grade, and the parking brake was not engaged, the vehicle could roll away. Correction: Dealers will replace the guide plate.