Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2006 Pierce Enforcer, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Pierce Manufacturing (Pierce) is recalling certain 2004-2018 Arrow XT, Dash, Enforcer, Impel, Quantum and Velocity aerial vehicles. The aerial device may unexpectedly rotate to the right when the ladder is being extended. Remedy: Pierce will notify owners, and dealers will reprogram the aerial control module, free of charge. The recall began February 28, 2019. Owners may contact Pierce customer service at 1-888-974-3723. Pierce's number for this recall is 74B295.
Pierce Manufacturing (Pierce) is recalling certain 1999-2013 Arrow XT, Dash, Enforcer, Quantum and Velocity fire trucks equipped with the electric All-steer rear steering option. The affected vehicles have rear steer axle shafts that were not properly heat treated. Remedy: Pierce will notify owners, and dealers will replace the rear steer axle shafts, free of charge. An interim notice was mailed on July 24, 2017. The recall began June 3, 2020. Owners may contact Pierce customer service at 1-888-974-3723.
Pierce Manufacturing (Pierce) is recalling certain model year 2006-2007 Arrow XT, Dash, Enforcer, Lance, Impel, and Quantum vehicles manufactured January 1, 2006, to March 31, 2007. In the affected vehicles, tears in the ball joint protective boots may result in contamination of the ball joints. Remedy: Pierce will notify owners, and dealers will inspect the affected vehicles for torn ball joint boots. Pierce will also evaluate the ball joint wear. Ball joints with an unexpected level of wear will be replaced. These repairs will be performed free of charge. The recall began on December 10, 2015. Owners may contact Pierce customer service at 1-888-974-3723. Pierce's number for this recall is 74B267.
PIERCE IS RECALLING CERTAIN MODEL YEAR 1999-2008 ARROW XT, DASH, LANCE, AND ENFORCER FIRE APPARATUS MANUFACTURED FROM JUNE 22, 1999, THROUGH MAY 12, 2008, AND EQUIPPED WITH AN ELECTRONIC ACCELERATOR PEDAL. AFTER REPEATED USE WITH EXCESSIVE FORCE, THE ACCELERATOR PEDAL ARM MAY BEND AND CAUSE THE PEDAL TO MOVE CLOSER TO THE FLOOR. IF THE PEDAL ARM BENDS FAR ENOUGH, THE PEDAL MAY CONTACT THE CAB FLOOR WITHOUT WARNING AND STICK IN THE FULL THROTTLE POSITION. Remedy: DEALERS WILL REMOVE THE EXISTING ACCELERATOR ARM AND INSTALL A REDESIGNED PEDAL ARM FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR ABOUT MAY 9, 2011. OWNERS MAY CONTACT PIERCE AT 1-920-832-3000.
Pierce Manufacturing Inc. (Pierce) is recalling certain model year 2000-2009 Enforcer and model year 2000-2010 Dash, Lance, and Arrow XT vehicles. While raising or lowering the cab as part of vehicle maintenance, the mounts on which the cab tilt cylinders pivot may fatigue and fail allowing the cab to fall until the safety catch activates. Remedy: Pierce will notify owners, and dealers will affix new safety signs advising the operator to stay clear of the cab while it is being tilted, free of charge. The recall began on January 6, 2014. Owners may contact Pierce at 1-920-832-3000. Pierce's recall number is 74B240.
PIERCE IS RECALLING CERTAIN MODEL YEAR 2003 THROUGH 2009 CUSTOM CONTENDER, DASH, ENFORCER, IMPEL, LANCE SABER, AND VELOCITY FIRE TRUCKS MANUFACTURED FROM FEBRUARY 20, 2003, THROUGH MARCH 27, 2009. THESE TRUCKS MAY BE EQUIPPED WITH DROP-DOWN FIRE HOSE TRAYS MOUNTED UNDER THE FRONT BUMPER. THE HOSE TRAY LATCH MAY ACCIDENTALLY OPEN WHILE THE VEHICLE IS IN MOTION. Remedy: A NEW AND IMPROVED LATCH DESIGN HAS BEEN DEVELOPED AND A NEW HOSE BOX INCORPORATING THE NEW LATCH WILL BE INSTALLED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON OCTOBER 4, 2010. OWNER MAY CONTACT PIERCE AT 1-920-832-3000.
PIERCE IS RECALLING CERTAIN MODEL YEAR 1998 THROUGH 2008 ARROW XT, LANCE, VELOCITY, ENFORCER, IMPEL, AND DASH CUSTOM FIRE APPARATUS VEHICLES MANUFACTURED FROM MAY 30, 1998 THROUGH NOVEMBER 25, 2008. THE STEERING GEAR BRACKET MAY FRACTURE AND BREAK. IF THIS OCCURS THE STEERING GEAR MAY DETACH FROM THE VEHICLE. Remedy: PIERCE WILL NOTIFY OWNERS AND DEALERS WILL INSTALL A NEW STEERING GEAR MOUNTING BRACKET FREE OF CHARGE. THE SAFETY RECALL BEGAN ON OCTOBER 12, 2010. OWNERS ARE BEING INSTRUCTED TO INSPECT THE STEERING GEAR BRACKET PRIOR TO EACH TRIP. THE REMEDY TO REPAIR THIS DEFECT IS EXPECTED TO BEGIN NO EARLIER THE JANUARY 31, 2011. OWNERS MAY CONTACT PIERCE AT 1-888-974-3723.
PIERCE IS RECALLING CERTAIN MODEL YEAR 2006 THROUGH 2010 ARROW XT, DASH, ENFORCER, IMPEL, QUANTUM, AND VELOCITY FIRE TRUCKS MANUFACTURED FROM OCTOBER 11, 2006 THROUGH JUNE 16, 2010 AND EQUIPPED WITH MERITOR WABCO EX225 REAR DISC BRAKES AND ONSPOT AUTOMATIC TIRE CHAINS. THE MERITOR WABCO EX225 REAR DISC BRAKE CALIPER MAY INTERFERE WITH THE ONSPOT AUTOMATIC TIRE CHAIN BRACKETS. THIS INTERFERENCE MAY RESTRICT THE CALIPER FROM FULL MOVEMENT. Remedy: DEALERS WILL INSTALL NEW AUTOMATIC TIRE CHAIN BRACKETS. THE NEW BRACKETS PROVIDE ADDITIONAL CLEARANCE FOR THE FULL ACTUATION OF THE DISC BRAKE CALIPERS. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN IN JULY 2010. OWNERS MAY CONTACT PIERCE AT 1-920-832-3000.
ON CERTAIN FIRE TRUCKS EQUIPPED WITH CUMMINS ISL CM850 DIESEL ENGINES, THE CONNECTING RODS WHICH TRANSFER ENERGY FROM THE PISTON TO THE CRANKSHAFT ARE DEFECTIVE AND CAN RESULT IN SEIZURE OF THE PISTON PIN. A PISTON PIN SEIZURE CAN RESULT IN A MISSION-DISABLING ENGINE FAILURE. Remedy: PIERCE IS WORKING WITH CUMMINS TO REPLACE THE CONNECTING RODS FREE OF CHARGE. OWNERS MAY CONTACT PIERCE AT 1-888-974-3723 OR CUMMINS AT 1-800-DIESELS.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain fire trucks, a defect in the ball joint boots could allow corrosion to form in the joint, leading to accelerated wear. This could cause premature ball joint failure, potentially resulting in a loss of steering control which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the ball joints and repair as necessary.
On certain trucks, the trunnion ears on the cab tilt cylinders pivot may fail while the cab is being raised or lowered for vehicle servicing or maintenance. This would allow the cab to drop until the safety flow velocity fuses engage and stop cab movement. A person in the path of the moving cab may be injured as a result. Correction: Dealers will install safety signs instructing operators to stand clear of cab while it is being tilted.
On certain fire trucks, after repeated use with excessive force, the accelerator pedal arm may bend and cause the foot pedal to move closer to the floor. If the pedal arm bends far enough, the foot pedal may contact the cab floor without warning and stick in the full throttle position. An accelerator pedal stuck at full throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could result in a loss of control and a crash causing property damage and/or personal injury. Correction: Dealers will replace the accelerator pedal arm with a redesigned version.
On certain vehicles equipped with a non-independent front suspension, the steering gear bracket may fracture and break. If this occurs the steering gear may detach from the vehicle, without warning, and cause a crash. Correction: A new steering gear mounting bracket will be installed.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
On certain fire trucks, the pitman arm may fracture under severe load caused by three loading conditions. In all cases, the front axle must be turned full left or right while: 1) simultaneously backing-up and braking hard, 2) driving one wheel over or against a curb, or, 3) steering the front axle full left or right when the vehicle is stationary. These are all low or no-speed events. Correction: Dealers will install pitman arms made of higher strength material.