Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2007 GMC Acadia, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
General Motors LLC (GM) is recalling certain model year 2008-2012 Buick Enclave vehicles manufactured January 3, 2007, to February 29, 2012, 2009-2012 Chevrolet Traverse vehicles manufactured July 6, 2008, to March 9, 2012, 2007-2012 GMC Acadia vehicles manufactured September 15, 2006, to February 29, 2012, and 2007-2010 Saturn Outlook vehicles manufactured August 17, 2006, to March 18, 2010. The affected vehicles, equipped with the power liftgate option, have gas struts that hold the power liftgate up when open. These struts may prematurely wear and the open liftgate may suddenly fall. Remedy: GM will notify owners, and dealers will update the software for the power liftgate actuator motor control unit so that the motor will prevent the rapid closing of the lift gate, free of charge. The recall began on November 15, 2016. Owners may contact Buick customer service at 1-800-521-7300, Chevrolet customer service at 1-800-222-1020, GMC customer service at 1-800-462-8782, and Saturn customer service at 1-800-553-6000. GM's number for this recall is 15240.
GM IS RECALLING 857,735 MY 2006-2008 BUICK LUCERNE; CADILLAC DTS; HUMMER H2; MY 2007-2008 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT; CHEVROLET AVALANCHE, SILVERADO, SUBURBAN, TAHOE; GMC ACADIA, SIERRA, YUKON, YUKON XL, SATURN OUTLOOK; AND MY 2008 BUICK ENCLAVE VEHICLES EQUIPPED WITH A HEATED WIPER WASHER FLUID SYSTEM. A SHORT CIRCUIT ON THE PRINTED CIRCUIT BOARD FOR THE WASHER FLUID HEATER MAY OVERHEAT THE CONTROL-CIRCUIT GROUND WIRE. Remedy: DEALERS WILL INSTALL A WIRE HARNESS WITH AN IN-LINE FUSE FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 12, 2008. OWNERS MAY CONTACT BUICK AT 1-866-608-8080; CADILLAC AT 1-800-982-2339 OR HTTP://WWW.CADILLAC.COM; CHEVROLET AT 1-800-630-2438; SATURN AT 1-800-972-8876 OR HTTP://WWW.SATURN.COM, GMC AT 1-866-996-9436; OR HUMMER AT 1-800-732-5493; OR THROUGH THEIR WEBSITE AT <A HREF=HTTP://WWW.GMOWNERCENTER.COM>HTTP://WWW.GMOWNERCENTER.COM</A> .
GM IS RECALLING CERTAIN MODEL YEAR 2006-2009 BUICK, LUCERNE; CADILLAC DTS; HUMMER H2; MODEL YEAR 2008-2009 BUICK ENCLAVE; CADILLAC CTS; MODEL YEAR 2007-2009 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT; CHEVROLET AVALANCHE, SILVERADO, SUBURBAN, TAHOE; GMC ACADIA, SIERRA, YUKON, YUKON XL; SATURN OUTLOOK; AND MODEL YEAR 2009 CHEVROLET TRAVERSE VEHICLES EQUIPPED WITH A HEATED WASHER FLUID SYSTEM (HWFS). A RECALL WAS IMPLEMENTED IN 2008 TO ADD A FUSE TO THE CONTROL CIRCUIT HARNESS TO ADDRESS THE POTENTIAL CONSEQUENCES OF A PRINTED CIRCUIT BOARD (PCB) ELECTRICAL SHORT. HOWEVER, THERE HAVE BEEN NEW REPORTS OF THERMAL INCIDENTS ON HWFS MODULES AFTER THIS IMPROVEMENT WAS INSTALLED. THESE INCIDENTS RESULTED FROM A NEW FAILURE MODE ATTRIBUTED TO THE DEVICE'S THERMAL PROTECTION FEATURE. THE SIGNIFICANCE VARIES FROM MINOR DISTORTION TO CONSIDERABLE MELTING OF THE PLASTIC AROUND THE HWFS FLUID CHAMBER. Remedy: DEALERS WILL PERMANENTLY DISABLE AND REMOVE THE HEATED WASHER FLUID MODULE. AN UPDATED PAGE FOR THE OWNER MANUAL WILL BE PROVIDED AND INSERTED IN THE OWNER MANUAL TO DOCUMENT THAT THE FEATURE HAS BEEN PERMANENTLY DISABLED AND REMOVED FROM THE VEHICLE. THE SAFETY RECALL BEGAN ON JUNE 11, 2010. OWNERS MAY CONTACT BUICK AT 1-866-608-8080, CADILLAC AT 1-866-982-2339, CHEVROLET AT 1-800-630-2438, SATURN AT 1-800-972-8876, GMC AT 1-866-996-9463 AND HUMMER AT 1-800-732-5493 OR AT THE OWNER CENTER AT WWW.GMOWNERCENTER.COM.
GM IS RECALLING 88,809 MY 2008 BUICK ENCLAVE, AND MY 2007-2008 GMC ACADIA AND SATURN OUTLOOK VEHICLES CURRENTLY OR PREVIOUSLY REGISTERED IN THE FOLLOWING STATES: ALASKA, COLORADO, CONNECTICUT, DELAWARE, IDAHO, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MONTANA, NEBRASKA, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, NORTH DAKOTA, OHIO, PENNSYLVANIA, RHODE ISLAND, SOUTH DAKOTA, UTAH, VERMONT, WEST VIRGINIA, WISCONSIN, WYOMING, AND THE DISTRICT OF COLUMBIA. IF A BUILDUP OF SNOW OR ICE ON THE WINDSHIELD OR ON THE WIPERS RESTRICTS THE MOVEMENT OF THE WIPER ARM, THE WINDSHIELD WIPER LINKAGE MAY BECOME DETACHED FROM THE MOTOR SHAFT AND THE WIPERS MAY BECOME INOPERATIVE. Remedy: DEALERS WILL INSTALL A NEW WIPER CRANK ARM, DRIVER'S SIDE LINK, AND A CRANK ARM NUT. THE RECALL BEGAN O OCTOBER 13, 2008. OWNERS MAY CONTACT BUICK AT 1-866-608-8080, GMC AT 1-866-996-9463, SATURN AT 1-800-972-8876, OR THROUGH THEIR WEBSITE AT <A HREF=HTTP://WWW.GMOWNERCENTER.COM>HTTP://WWW.GMOWNERCENTER.COM</A> .
ON CERTAIN VEHICLES, THE SENSING AND DIAGNOSTIC MODULE (SDM), WHICH CONTROLS THE FUNCTION OF FRONT AIR BAGS, MAY NOT OPERATE PROPERLY. AS A RESULT, THE FRONT AIR BAGS MAY FAIL TO DEPLOY IN A FRONTAL CRASH. ALSO, THE AIR BAG WARNING LAMP ON THE INSTRUMENT PANEL MAY FAIL TO PROVIDE WARNING THAT THE SYSTEM IS INOPERATIVE. Remedy: DEALERS WILL REPROGRAM THE SDM COMPUTER MODULE. THIS RECALL BEGAN ON FEBRUARY 22, 2007. OWNERS MAY CONTACT GMC AT 1-866-966-9463 OR SATURN AT 1-800-972-8876.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act. Safety Risk: Glass that breaks in to large pieces could create a risk of injury. Corrective Actions: The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.
On certain vehicles equipped with a power liftgate system, the gas-filled struts (which help to raise and support the liftgate) may prematurely wear. These vehicles have a Prop Rod Recovery system intended to accomplish a controlled, slow return of the liftgate to the closed position if the liftgate’s gas struts are no longer capable of supporting the weight of the liftgate. The vehicle would provide audible warnings and flash the tail lamps to indicate there is a problem. However, the liftgate’s Prop Rod Recovery system software may be unable to detect/stop a liftgate with prematurely worn gas struts from falling too quickly after the liftgate is opened. This could allow the liftgate to drop suddenly, placing anyone beneath or near the gate at risk of injury. Correction: Dealers will reprogram the power liftgate actuator motor ECU with a new software and will verify power liftgate operation following the reprogram.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles equipped with a Heated Washer Fluid System (HWFS), a short circuit on the printed circuit board for the washer fluid heater may overheat the control-circuit ground wire. A repair was implemented in a recall in 2008, however, there have been new reports of thermal incidents on heated washer fluid system modules after this improvement was installed. This situation may cause some minor distortion, but also could lead to melting of the plastic around the heated washer fluid system, or cause a fire. Correction: Dealers will permanently disable and remove the heated washer fluid module. An updated page will be provided and inserted in the Owner Manual to document the removal of the feature.
On certain vehicles equipped with a heated washer fluid system, a short circuit on the printed circuit board for the washer fluid heater may overheat the control-circuit ground wire. This situation may cause other electrical features to malfunction which could cause smoke and in some cases a fire. Correction: Dealer will install a wire harness with an in-line fuse.
On certain vehicles registered in areas with moderate to heavy snowfall, a buildup of snow or ice on the windshield or wipers could restrict the movement of the wiper arm and the wiper linkage may become detached from motor shaft and the wipers will become inoperative. This situation, in conjunction with traffic, road conditions, and driver's reactions, could increase the risk of a crash. Correction: Dealers will install a new wiper crank arm, driver's side link, and crank arm nut.
On certain vehicles, the sensing and diagnostic module (SDM), which controls the function of front airbags, may not operate properly. As a result, the front airbags may fail to deploy in a frontal crash. Also, the airbag warning lamp in the instrument panel may fail to provide warning that the system is inoperative. Failure to deploy the front airbags during a crash could leave seat occupants susceptible to increase injuries. Correction: Dealers will re-program the SDM.