Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2008 GMC Sierra, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
GM IS RECALLING 857,735 MY 2006-2008 BUICK LUCERNE; CADILLAC DTS; HUMMER H2; MY 2007-2008 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT; CHEVROLET AVALANCHE, SILVERADO, SUBURBAN, TAHOE; GMC ACADIA, SIERRA, YUKON, YUKON XL, SATURN OUTLOOK; AND MY 2008 BUICK ENCLAVE VEHICLES EQUIPPED WITH A HEATED WIPER WASHER FLUID SYSTEM. A SHORT CIRCUIT ON THE PRINTED CIRCUIT BOARD FOR THE WASHER FLUID HEATER MAY OVERHEAT THE CONTROL-CIRCUIT GROUND WIRE. Remedy: DEALERS WILL INSTALL A WIRE HARNESS WITH AN IN-LINE FUSE FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 12, 2008. OWNERS MAY CONTACT BUICK AT 1-866-608-8080; CADILLAC AT 1-800-982-2339 OR HTTP://WWW.CADILLAC.COM; CHEVROLET AT 1-800-630-2438; SATURN AT 1-800-972-8876 OR HTTP://WWW.SATURN.COM, GMC AT 1-866-996-9436; OR HUMMER AT 1-800-732-5493; OR THROUGH THEIR WEBSITE AT <A HREF=HTTP://WWW.GMOWNERCENTER.COM>HTTP://WWW.GMOWNERCENTER.COM</A> .
GM IS RECALLING CERTAIN MODEL YEAR 2006-2009 BUICK, LUCERNE; CADILLAC DTS; HUMMER H2; MODEL YEAR 2008-2009 BUICK ENCLAVE; CADILLAC CTS; MODEL YEAR 2007-2009 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT; CHEVROLET AVALANCHE, SILVERADO, SUBURBAN, TAHOE; GMC ACADIA, SIERRA, YUKON, YUKON XL; SATURN OUTLOOK; AND MODEL YEAR 2009 CHEVROLET TRAVERSE VEHICLES EQUIPPED WITH A HEATED WASHER FLUID SYSTEM (HWFS). A RECALL WAS IMPLEMENTED IN 2008 TO ADD A FUSE TO THE CONTROL CIRCUIT HARNESS TO ADDRESS THE POTENTIAL CONSEQUENCES OF A PRINTED CIRCUIT BOARD (PCB) ELECTRICAL SHORT. HOWEVER, THERE HAVE BEEN NEW REPORTS OF THERMAL INCIDENTS ON HWFS MODULES AFTER THIS IMPROVEMENT WAS INSTALLED. THESE INCIDENTS RESULTED FROM A NEW FAILURE MODE ATTRIBUTED TO THE DEVICE'S THERMAL PROTECTION FEATURE. THE SIGNIFICANCE VARIES FROM MINOR DISTORTION TO CONSIDERABLE MELTING OF THE PLASTIC AROUND THE HWFS FLUID CHAMBER. Remedy: DEALERS WILL PERMANENTLY DISABLE AND REMOVE THE HEATED WASHER FLUID MODULE. AN UPDATED PAGE FOR THE OWNER MANUAL WILL BE PROVIDED AND INSERTED IN THE OWNER MANUAL TO DOCUMENT THAT THE FEATURE HAS BEEN PERMANENTLY DISABLED AND REMOVED FROM THE VEHICLE. THE SAFETY RECALL BEGAN ON JUNE 11, 2010. OWNERS MAY CONTACT BUICK AT 1-866-608-8080, CADILLAC AT 1-866-982-2339, CHEVROLET AT 1-800-630-2438, SATURN AT 1-800-972-8876, GMC AT 1-866-996-9463 AND HUMMER AT 1-800-732-5493 OR AT THE OWNER CENTER AT WWW.GMOWNERCENTER.COM.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: Long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, may eventually degrade the propellant contained in the passenger-front airbag. This could cause the airbag to deploy with more force than normal. If the airbag inflator ruptures, fragments could be propelled toward vehicle occupants or cause damage to the airbag assembly, preventing its proper function. Note: For 2009 models listed, this recall only affects vehicles that were imported into Canada, and were originally sold or ever registered in certain areas of the United States that experience high or moderate levels of heat and humidity. Safety Risk: If the vehicle is involved in a crash requiring an airbag deployment, the airbag inflator could rupture and create a risk of injury. Corrective Action: General Motors will notify owners by mail and instruct you to take your vehicle to a dealer to replace the passenger-front airbag. Note: The Canadian climate results in the propellant degrading slowly. This recall is being conducted as a precaution to address future risk. It is expected that all airbag inflators will be replaced before their function would be affected.
Issue: Long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, may eventually degrade the propellant contained in the passenger-front airbag. This could cause the airbag to deploy with more force than normal. If the airbag inflator ruptures, fragments could be propelled toward vehicle occupants or cause damage to the airbag assembly, preventing its proper function. Note: This recall is for vehicles that were originally sold or ever registered in certain areas of the United States that experience high or moderate levels of heat and humidity, and that were subsequently imported into Canada. Affected states: American Samoa and the U.S. Virgin Islands, Alabama, Arizona, Arkansas, California, Delaware, District of Columbia, Florida, Georgia, Guam, Hawaii, Illinois, Indiana, Kansas, Kentucky, Louisiana, Maryland, Mississippi, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Puerto Rico, South Carolina, Tennessee, Texas, the Northern Mariana Islands (Saipan), Virginia and West Virginia. Safety Risk: If the vehicle is involved in a crash requiring an airbag deployment, the airbag inflator could rupture and create a risk of injury. Corrective Actions: General Motors will notify owners by mail and instruct you to take your vehicle to a dealer to replace the passenger-front airbag inflator. Note: This recall is being conducted as a precaution to address future risk. It is expected that all airbag inflators will be replaced before their function would be affected.
We checked the EU Safety Gate for recall alerts naming this model and its production years.
Source: EU Safety Gate (European Commission) · CC BY 4.0, © European Union
The propellant used in the passenger-side frontal airbag inflator may experience a material alteration over time due to degradation occurring after prolonged exposure to high absolute humidity, high temperatures and high-temperature cycling. In the event of an airbag being deployed, the excessive internal pressure may cause the inflator body to rupture and metal fragments may pass through the cushion material causing injury to the occupants. Production: 2007-2013. Types: Cadillac: e13*2001/116*0191*00-*04 and *09, e13*2001/116*1011*00-*06; Chevrolet and GMV: Individual approval.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
This Safety Improvement Program was replaced by Transport Canada Recall No. 2020-591. General Motors Canada is conducting a voluntary Safety Improvement Program involving passenger airbag inflators in vehicles that were originally sold or ever registered in certain areas of the United States that experience high or moderate levels of heat and humidity, and that were subsequently imported into Canada. Dealers will replace the passenger inflator on affected vehicles. Owners who believe their vehicles may have been originally purchased or registered in the states listed below should contact a General Motors dealer. This action is not being conducted under the requirements of the Motor Vehicle Safety Act. Affected states: American Samoa and the U.S. Virgin Islands, Alabama, Arizona, Arkansas, California, Delaware, District of Columbia, Florida, Georgia, Guam, Hawaii, Illinois, Indiana, Kansas, Kentucky, Louisiana, Maryland, Mississippi, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Puerto Rico, South Carolina, Tennessee, Texas, the Northern Mariana Islands (Saipan), Virginia and West Virginia.
On certain 2500HD and 3500HD series pickup trucks, the passenger frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture, which could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. This could also damage the airbag module, which could prevent proper deployment. Failure of the passenger airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Correction: Dealers will replace airbag inflators.
On certain vehicles, the Sensing and Diagnostic Module (SDM) may corrode due to a significant quantity of snow and/or water containing road salt or other contaminants entering the vehicle and saturating the acoustical padding beneath the floor carpet. If sufficient moisture collects and is retained in the padding, it may cause excessive corrosion under the module; compromising the module seal and allowing water intrusion and system malfunction. This may result in illumination of the Airbag Readiness light along with a "Service Airbag" message on the Driver Information Center and, in certain instances, may cause inadvertent deployment of the seatbelt pretensioner and/or airbags. Inadvertent airbag and/or pretensioner deployment could result in injury and/or damage to property. Correction: Dealers will remove the acoustical pad above the SDM, inspect, and if necessary, replace the SDM. Note: This is an expansion of recall 2009-291
*** This notice is provided for information purposes only as the subject equipment is not regulated under the Motor Vehicle Safety Act *** A safety defect may exist in aftermarket ACDelco brake shoes manufactured between April 1st 2013 to April 19 2014, sold and/or installed as service replacement parts. The lining of the rear brake shoe may detach from the steel shoe during normal service, causing the affected brake to fail. If the lining detaches from the steel shoe, it could cause rear-wheel lockup and it will reduce the available braking force which could lengthen the required stopping distance, and increase the risk of a crash without prior warning. Correction: GM Dealers, ACDelco warehouse distributors and their professional installer customers are to inspect the manufacture date of the rear brake shoes and, if necessary, replace the shoes. Customers of the 125 vehicles that were serviced by GM Dealers with the suspect parts will be notified by first class letter.
On certain vehicles equipped with an optional dual batteries, the owner's manual does not specify a maximum amperage rating for the auxiliary battery to the trailer wiring harness. If the circuit is overloaded, a fusible link may fail and could damage adjacent components, potentially resulting in a fire and increasing the risk of injury and/or damage to property. Correction: Dealers will install an 40 amp inline fuse and provide an owner's manual supplement containing maximum amp rating information. Note: Owners are advised not to use equipment that exceeds a 40 amp draw on the auxiliary battery trailer wiring.
On certain vehicles equipped with a Heated Washer Fluid System (HWFS), a short circuit on the printed circuit board for the washer fluid heater may overheat the control-circuit ground wire. A repair was implemented in a recall in 2008, however, there have been new reports of thermal incidents on heated washer fluid system modules after this improvement was installed. This situation may cause some minor distortion, but also could lead to melting of the plastic around the heated washer fluid system, or cause a fire. Correction: Dealers will permanently disable and remove the heated washer fluid module. An updated page will be provided and inserted in the Owner Manual to document the removal of the feature.
On certain vehicles located in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundland & Labrador, the Sensing and Diagnostic Module (SDM) may corrode due to a significant quantity of snow and/or water containing road salt or other contaminants entering the vehicle and saturating the acoustical padding beneath the floor carpet. If sufficient moisture collects and is retained in the padding, it may cause excessive corrosion under the module; compromising the module seal and allowing water intrusion and system malfunction. This may result in illumination of the Airbag Readiness light along with a "Service Airbag" message on the Driver Information Center and, in certain instances, may cause inadvertent deployment of the seatbelt pretensioner and/or airbags. Inadvertent deployment of the driver and / or passenger front airbag in a non-accident (non-impact) situation may cause damage to the surrounding vehicle environment (windshield / instrument panel), and create expensive vehicle repair, including replacement of the airbag module(s). In some instances, inadvertent deployment could cause minor injuries to vehicle occupants. Correction: Dealers will remove the acoustic pad above the SDM.
On certain vehicles equipped with a heated washer fluid system, a short circuit on the printed circuit board for the washer fluid heater may overheat the control-circuit ground wire. This situation may cause other electrical features to malfunction which could cause smoke and in some cases a fire. Correction: Dealer will install a wire harness with an in-line fuse.