Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2008 Mitsubishi Lancer, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Mitsubishi Motors North America, Inc. (MMNA) is recalling certain 2008-2010 Lancer, 2009-2010 Lancer Sportback, 2008-2013 Outlander, and 2011-2016 Outlander Sport vehicles originally sold in, or ever registered in, Connecticut, Delaware, the District of Columbia, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, and Wisconsin. The front lower control arms may detach due to the front cross member corroding from salt water exposure such as from road salt use. Remedy: MMNA will notify owners, and dealers will inspect the front cross members. Depending on the level of existing corrosion, either a sealing/anti-corrosion agent will be applied or the front cross member will be replaced with a new one. These repairs will be performed free of charge. The recall began August 7, 2020. Owners may contact MMNA customer service at 1-888-648-7820. MMNA's number for this recall is SR-20-003.
Mitsubishi Motors North America, Inc. (MMNA) is recalling certain 2007-2010 Outlander, 2008-2010 Lancer, 2009-2010 Lancer Evolution, and 2010 Lancer Sportback vehicles equipped with sunroofs. The sunroof glass may detach from the sunroof assembly, becoming a road hazard to other vehicles. Remedy: MMNA will notify owners, and dealers will replace the sunroof glass assembly, free of charge. The recall began on February 27, 2018. Owners may contact MMNA customer service at 1-888-648-7820. MMNA's number for this recall is SR-18-003.
Mitsubishi Motors North America, Inc. (Mitsubishi) is recalling certain model year 2008-2011 Lancer, Lancer Evolution, and Outlander; 2009-2011 Lancer Sportback, Lancer Rilliart, and Lancer Sportback Ralliart; and 2011 Outlander Sport vehicles. The affected vehicles, manufactured with 4B1 engines, have an engine pulley and belt arrangement for turning the alternator, the cooling fan and the power steering pump (if equipped). These pulleys may experience unusual wear and allow for belt detachment. Remedy: Mitsubishi will notify owners, and dealers will replace the drive belt with a rubber belt. Drive pulleys that are excessively worn will be replaced. These repairs will be performed free of charge. The recall began on October 15, 2014. Owners may contact Mitsubishi customer service at 1-888-648-7820. Mitsubishi's number for this recall is SR-14-009.
MITSUBISHI IS RECALLING 39,711 MY 2008-2009 OUTLANDER AND LACER VEHICLES. INCORRECT MATERIAL COMPOSITION OF THE BRAKE BOOSTER CHECK VALVE MAY CAUSE THE CHECK VALVE TO STICK CLOSED WHEN THE ENGINE IS SHUT OFF. WHEN THE VEHICLE IS RE-STARTED AND PUT INTO MOTION, UNDER CERTAIN DRIVING CONDITIONS (VERY SLOW VEHICLE MANEUVERS), THERE MAY BE INSUFFICIENT INITIAL BRAKING ASSIST. Remedy: DEALERS WILL REPLACE THE BRAKE BOOSTER CHECK VALVE FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN DURING APRIL 2009. OWNERS MAY CONTACT MITSUBISHI AT 1-800-222-0037.
MITSUBISHI IS RECALLING MODEL YEAR 2008-2009 LANCER AND LANCER EVOLUTION VEHICLES ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, KENTUCKY, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, VIRGINIA, WEST VIRGINIA, WISCONSIN AND DISTRICT OF COLUMBIA. IN AREAS WHERE HEAVY ROAD SALT IS USED IN THE WINTER, A LONG TERM EXPOSURE TO A MIXTURE OF MELTED SNOW WITH SALT THROWN UP BY THE OTHER VEHICLES ON THE ROAD MAY CAUSE A WATER-SALT MIXTURE TO ADHERE TO THE FRONT IMPACT SENSORS. Remedy: DEALERS WILL INSTALL NEW FRONT AIRBAG SENSORS THAT HAVE IMPROVED CORROSION RESISTANCE. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON NOVEMBER 27, 2009. OWNERS MAY CONTACT MITSUBISHI CUSTOMER RELATIONS DEPARTMENT AT 1-888-648-7820.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: On certain vehicles, road salt can corrode the front cross-member (subframe). As a result, a lower control arm could eventually detach from the cross-member. This could cause a loss of vehicle control. Safety Risk: A loss of control can create the risk of a crash. Corrective Actions: Mitsubishi will notify owners by mail and instruct you to take your vehicle to a dealer to inspect the front cross-member (subframe). If no significant corrosion is found, the dealer will spray a sealing and anti-corrosion coating both inside and on the cross-member. If significant corrosion is found, the dealer will replace the cross-member.
On certain vehicles, water may drain from the windshield cowl area onto the front wiper link ball joint. Over time, this could result in corrosion and/or wear to the joint, which could result in the separation of the wiper link ball. If separation were to occur, the windshield wipers could become inoperative, which could limit the driver’s visibility under certain operating conditions which may increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the wiper link rod with a countermeasure one, and will replace the wiper motor crank arm with a new one.
On certain vehicles, the sunroof may not have been bonded properly and could separate from the vehicle. This could pose a risk to other road users, increasing the risk of injury and/or damage to property. Correction: Dealers will replace the sunroof glass assembly.
On certain vehicles operated in areas of heavy road salt usage, a mixture of snow, water and road-salt solution may infiltrate between the front impact sensor and the bracket that attaches it to the vehicle. Over time, repeated freezing/thawing cycles could cause a crack to develop in the sensor case allowing water intrusion and short circuit of the sensor. In the event of a crash, this could result in delayed deployment of the driver and passenger front airbags which would increase the risk of injury. Correction: Dealers will inspect the front impact sensor and replace it if it is found to be cracked. An updated designed bracket and cover will also be installed.
We checked the EU Safety Gate for recall alerts naming this model and its production years.
Source: EU Safety Gate (European Commission) · CC BY 4.0, © European Union
The ammonium nitrate propellant used in the air bag inflator may degrade over time. Production: Production period: from June 2003 to December 2008.. Types: Model: Lancer (CS0A, CS0W, CT9A); Model year: 2004 to 2007; EC-type approval number: e1*2001/116*0233*00; e1*2001/116*0259*00;.
The flange area of the engine's multi-belt auto tensioner may crack under high-load driving conditions, which may cause the drive-belt to fall off. Production: Model year: ASX (2011–2012), Lancer (2008-2012), Outlander (2008-2012); ; VIN: JMBXTCW5W9F004919. Production period: 08/04/2009.. Types: EC-type approval number: e1*2001/116*0482*01; Model: ASX (GA0W), Lancer (CY0A), Outlander (CW0W);.
Due to temperature and humidity, the adhesive material between the sunroof glass and its outer frame may weaken. Production: Model year: 2008-2009 (Lancer), 2009-2010 (Lancer Sportback), 2006-2012 (Outlander) . Types: EC-type approval number: e1*2001/116*0406*00; e21*NKS*0001*01; Model: Lancer (CY0A), Lancer Sportback (CX0A), Outlander (CW0W);.
Production: Model years: 2003-2008 . Types: CS0A,CS0W,CT9A,HA1W.
Production: The Lancer Evolution 8/9 cars in question were models manufactured between 2005 and 2007. The Pajero (Shogun) cars in question were models manufactured between 2005 and 2006. Only right-hand-driv...... Types: Type: CT0 / V60 Sales description: CT0: Lancer Evolution 8/9 right-hand drive, V60: Pajero/Shogun right-hand drive EC type approval number: CT0: e1*2001/116*0259*02-04 V60: e1*98/14*0142*07-09.
How cars of this model and year did at Norway's periodic inspection, across a full year of tests.
Source: Statens vegvesen, periodic inspections (EU-kontroll) · CC BY 4.0
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, the drive belt material may cause abnormal pulley wear. If the vehicle is driven under this condition, the drive belt may become damaged from the worn pulley and detach, affecting electrical charging system and cooling system function and would illuminate the engine warning lamp(s) on the instrument panel. This could result in battery depletion and an overheated engine, resulting in a loss of motive power. Vehicles equipped with a hydraulic power steering system could also experience loss of power steering assist. These issues could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the drive belt, and the pulley will be replaced if it is found worn beyond a certain level.
On certain vehicles operated in areas of heavy road salt usage, the front impact sensors may corrode between the sensor bushing and sensor bracket. Over time, the corrosion may cause a crack to develop in the sensor case allowing water intrusion and short circuit of the sensor. This could result in delayed deployment of the driver and passenger front airbags during a vehicle crash, increasing the risk of personal injuries or death. Correction: Dealers will replace the front impact sensors.
On certain vehicles, the brake booster check valve may stick closed when the engine is shut off. When the vehicle is re-started and put into motion, under certain driving conditions (very slow vehicle manoeuvres), there may be insufficient initial braking assist, which could temporarily increase the stopping distance. This could result in a vehicle crash causing property damage, personal injury or death. Correction: Dealers will replace the brake booster check valve.
Production: Model years: ASX: 2011, Lancer: 2008 - 2011, Lancer Sportback: 2009 - 2011, Lancer Evolution: 2008 - 2011, Outlander: 2006 - 2011.. Types: ASX (GA0W), Lancer (CY0W), Lancer Sportback (CX0W), Evolution (CZ4A) and Outlander (CW0W).