Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2009 Chevrolet Impala, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
General Motors LLC (GM) is recalling certain model year 2009-2010 Chevrolet Impala vehicles manufactured April 25, 2008 through February 16, 2010. The front passenger seat frame may contact and damage the wires of the passenger presence sensor module. Remedy: GM will notify owners, and dealers will double wrap the wires with anti-abrasion tape and replace damaged wires as necessary, free of charge. The recall began on August 1, 2016. Owners may contact Chevrolet customer service at 1-800-521-7300. GM's recall campaign number is 36110.
This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. General Motors LLC (GM) is recalling certain model year 2005-2009 Buick LaCrosse, 2006-2011 Buick Lucerne, 2000-2005 Cadillac DeVille, 2006-2011 Cadillac DTS, 2006-2014 Chevrolet Impala, and 2006-2007 Chevrolet Monte Carlo vehicles. In the affected vehicles, the weight on the key ring and road conditions or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine. Remedy: GM will notify owners, and dealers will install two key rings and an insert in the key slot or a cover over the key head on all ignition keys, free of charge. The recall began on September 23, 2014. Owners may contact General Motors customer service at 1-800-521-7300 (Buick), 1-800-458-8006 (Cadillac), and 1-800-222-1020 (Chevrolet). GM's number for this recall is 14299.
General Motors (GM) is recalling certain model year 2008-2012 Chevrolet Impala police vehicles because the front lower control arms may fracture. This safety recall does not include non-police Chevrolet Impala vehicles. Remedy: GM will notify owners, and dealers will replace both front lower control arms, free of charge. The safety recall began on August 21, 2012. Owners may contact the Chevrolet owner center at 1-866-694-6546.
GM IS RECALLING CERTAIN MODEL YEAR 2009-2010 CHEVROLET IMPALAS FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." THE FRONT SAFETY BELT WEBBING MAY NOT HAVE BEEN PROPERLY SECURED TO THE LAP BELT ANCHOR PRETENSIONER MOUNTED TO THE SIDE OF THE SEAT NEAREST THE DOOR. Remedy: DEALERS WILL INSPECT BOTH FRONT SAFETY BELTS FOR PROPER INSTALLATION OF THE ANCHORS TO THE PRETENSIONERS AND, IF NECESSARY, REINSTALL THE ANCHORS. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON NOVEMBER 5, 2010. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438 OR AT THE OWNER CENTER AT WWW.GMOWNERCENTER.COM.
GM IS RECALLING 79 MY 2009 CHEVROLET IMPALA VEHICLES. SOME OF THESE VEHICLES HAVE A PASSENGER-SIDE FRONT AIR BAG INFLATOR THAT COULD FRACTURE AT AN INFLATOR TUBE DURING A DEPLOYMENT. Remedy: DEALERS WILL INSTALL A NEW PASSENGER-SIDE FRONT AIR BAG. THE RECALL BEGAN ON OCTOBER 10, 2008. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438 OR THROUGH THEIR WEBSITE AT <A HREF=HTTP://WWW.GMOWNERCENTER.COM>HTTP://WWW.GMOWNERCENTER.COM</A> .
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act. Safety Risk: Glass that breaks in to large pieces could create a risk of injury. Corrective Actions: The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.
On certain vehicles, the front passenger seat frame may damage the wires of the passenger presence sensor (PPS) module. If this occurs, the system may fail to detect an occupant in passenger seat and improperly suppress the front passenger airbag. The damage could also cause the airbag fuse to short, disabling air bags and seatbelt pretensioners. These issues could increase the risk of injury to vehicle occupants in a crash where airbag and/or pretensioner deployment is warranted. Correction: Dealers will inspect wiring and repair as necessary, as well as apply protective anti-abrasion tape. Note: If the passenger airbag is suppressed, the passenger airbag status indicator would indicate that the passenger airbag is off even when a passenger is sitting in the front passenger seat. In addition, the "service airbag" message would be displayed in the driver information centre (DIC). This could also cause the cluster gauges and DIC alerts to intermittently turn off or not function properly.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, a defect in the ignition switch could allow the switch to move out of the "run" position if the key ring is carrying added weight or the vehicle goes off-road or is subjected to some other jarring event. If this were to occur, engine power, power steering and power braking would be affected, increasing the risk of a crash causing injury and/or damage to property. The timing of the key movement out of the “run” position, relative to the activation of the sensing algorithm of the crash event, may also result in the airbags not deploying in a subsequent collision, increasing the risk of injury. Correction: For each key, dealers will install two key rings and modify the key ring opening shape. Note: Until the correction is performed, all items should be removed from the key ring.
On certain Chevrolet Impala police vehicles, the front control arms may fracture. If this occurs, some tire "squeal" or "chirping" may be heard when turning at low speeds. Sudden changes could occur in vehicle handling and, particularly at higher speeds, the driver may not be able to control the vehicle and a crash could occur, which may result in personal injury and/or property damage. Correction: Dealers will replace both control arms.
Certain vehicles fail to conform to Canada Motor Vehicle Safety Standard 210 - Seat Belt Assembly Anchorages. The front seatbelt webbing may not have been properly secured to the lap belt anchor pretensioner mounted to the side of the seat nearest the door. As a result, the seatbelt may not restrain the occupant as intended during a crash, which could result in injury to the occupant. Correction: Dealers will inspect both front seatbelts for proper installation of anchors to pretensioners and, if necessary, reinstall the anchors.
On certain vehicles, the passenger-side airbag inflator was not built to GM's Specification and could fracture during a deployment. Pieces of the inflator could strike and injure occupants and the airbag cushion would not inflate fully therefore reducing the capability of the airbag to protect the passenger. Correction: Dealers will install a new passenger-side airbag.