Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2009 Pontiac G8, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
General Motors LLC (GM) is recalling certain model year 2011-2013 Chevrolet Caprice vehicles manufactured October 15, 2010, to October 22, 2013, and 2008-2009 Pontiac G8 vehicles manufactured July 25, 2007, to February 18, 2009. In the affected vehicles, the flexible steel cables that connect the seat belts to the vehicle at the outside of the driver seat and the front passenger seat may be bent from being sat on while entering the vehicle. This repeated bending may result in the cable breaking. Remedy: GM will notify owners, and dealers will replace the seat belt tensioner assembly which includes the steel cable, free of charge. These replacement parts reposition the tensioner cable out of the path of entry into the vehicle and uses a more flexible cable, set at a more upright angle. The recall began on July 5, 2016. Owners may contact Chevrolet customer service at 1-800-222-1020 or Pontiac customer service at 1-800-762-2737. GM's number for this recall is 15206.
General Motors LLC (GM) is recalling certain model year 2011-2013 Chevrolet Caprice vehicles manufactured October 15, 2010, to December 6, 2013, and 2008-2009 Pontiac G8 vehicles manufactured July 25, 2007, to February 18, 2009. In the affected vehicles, the driver may accidentally hit the ignition key with their knee, unintentionally knocking the key out of the run position, turning off the engine. Remedy: GM will notify owners, and dealers will remove the key blade from the original flip key/RKE transmitter assemblies, and cut and fit a revised key blade and housing assembly, in which the blade has been indexed by 90 degrees, to the original RKE transmitter assembly. GM issued an interim notification to owners on December 31, 2014. The recall began on February 4, 2015. Owners may contact Chevrolet customer service at 1-800-222-1020 and Pontiac customer service at 1-800-762-2737. GM's number for this recall is 14445. Note: Until the recall has been performed, it is very important that drivers adjust their seat and steering column to allow clearance between their knee and the ignition key.
GENERAL MOTORS (GM) IS RECALLING CERTAIN MODEL YEAR 2008-2009 PONTIAC G8 VEHICLES MANUFACTURED FROM NOVEMBER 2, 2007 THROUGH JANUARY 22, 2009. A 5TH PERCENTILE FEMALE ANTHROPOMORPHIC TEST DEVICE (ATD) IN A 30 MPH FRONTAL BARRIER TEST EXCEEDED THE HEAD INJURY CRITERIA (HIC) REQUIREMENTS OF THE STANDARD. WITH THE FRONT PASSENGER SEAT POSITIONED FULL FORWARD, THE SEAT POSITION SENSOR WILL CAUSE A 30 MILLISECONDS DEPLOYMENT DELAY BETWEEN THE FIRST AND SECOND STAGES OF THE DUAL-STAGE FRONTAL PASSENGER AIR BAG. Remedy: GM DEALERS WILL REPROGRAM THE SENSING AND DIAGNOSTIC MODULE FREE OF CHARGE. THE SAFETY RECALL BEGAN ON NOVEMBER 30, 2011. OWNERS MAY CONTACT PONTIAC AT 1-800-620-7668.
GM IS RECALLING 35,038 MY 2008-2009 PONTIAC G8 VEHICLES FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT" AND FEDERAL MOTOR VEHICLES SAFETY STANDARD NO. 138, "TIRE PRESSURE MONITORING SYSTEMS". THE BRAKE PEDAL POSITION SWITCH MAY HAVE BEEN INCORRECTLY PROGRAMMED. WITH THIS CONDITION, THE BRAKE LAMPS MAY BE CONTINUALLY ILLUMINATED AND FAIL TO WARN A FOLLOWING DRIVER WHEN THE VEHICLE IS BRAKING. ALSO CERTAIN VEHICLES MAY HAVE INCORRECT VALUES PROGRAMMED INTO THE TIRE PRESSURE MONITORING SYSTEM THAT WILL NOT ILLUMINATE THE LOW TIRE PRESSURE TELLTALE UNTIL TIRE PRESSURE FALLS BELOW VALUES REQUIRED BY THE STANDARD. Remedy: DEALERS WILL REPROGRAM THE BRAKE POSITION SENSOR AND THE REMOTE CONTROL DOOR LOCK RECEIVER WITH THE CORRECT VALUES FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN ON OR BEFORE JUNE 5, 2009. OWNERS MAY CONTACT GM PONTIAC AT 1-800-620-7668.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, the flexible steel cable that connects the seat belt to the vehicle structure at the front outboard seating positions can fatigue over time and could separate, increasing the risk of injury in a crash. Correction: Dealers will replace the tensioner assembly.
On certain vehicles, there is a risk that some drivers may bump the ignition key with their knee and unintentionally move the key from out of the "run" position. If this were to occur, engine power, power braking and power steering would be affected, which would unexpectedly increase steering and brake pedal effort, potentially increasing stopping distances and the risk of a crash causing injury and/or damage to property. The timing of the key movement out of the "run" position, relative to the activation of the sensing algorithm of the crash event, may also result in the airbags not deploying in a subsequent collision, increasing the risk of injury. Correction: Dealers will remove the key blade from the original flip key/transmitter assemblies provided with the vehicle, and will cut and fit the revised key blade and housing assembly, in which the blade has been indexed by 90 degrees to the original transmitter assembly. Important note: Until the correction is performed, drivers should adjust their seat and steering column to allow clearance between their knee and the ignition key.
On certain vehicles, when the front passenger seat is in the full forward position, the seat position sensor may cause a deployment delay between the first and second stages of the dual-stage front passenger airbag. Failure of the airbag to deploy as intended during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Correction: Dealers will reprogram the Sensing and Diagnostic Module.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, the brake pedal position switch may have been incorrectly programmed during vehicle assembly. As a result, the brake lamps may remain illuminated when the brake pedal is released. Failure of the brake lamps to operate as intended may result in the following road users being unaware of the driver's intentions, increasing the risk of a crash causing personal injury or death. Correction: Dealers will reprogram the brake position sensor.