Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2010 International Prostar, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Navistar, Inc. (Navistar) is recalling certain model year 2010-2015 International Lonestar vehicles manufactured October 12, 2009, to June 16, 2014, and 2009-2015 International ProStar vehicles manufactured December 16, 2008, to June 20, 2014. In the affected vehicles the electrical harness that supplies power to the HVAC system may not be of sufficient size for the electrical load of the circuit. This can result in an increase in resistance and heating at the connectors. Remedy: Navistar will notify owners, and dealers will replace the 60 amp relay and battery harness with a 150 amp relay and battery harness, free of charge. Navistar issued an interim notification to owners on December 29, 2014. The recall began on March 2, 2015. Owners may contact Navistar customer service at 1-331-332-1590. Navistar's number for this recall is 14516.
NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2010-2012 PAYSTAR, WORKSTAR, TRANSTAR, AND PROSTAR COMMERCIAL TRUCKS MANUFACTURED FROM JUNE 1, 2009, THROUGH MAY 31, 2011, EQUIPPED WITH A MAXXFORCE 11 OR 13 ENGINE (FEATURE CODE 12UXJ OR 12UXH) AND WITH ALTERNATOR FEATURE CODE 08GGN, 08GGR, 08 GHG, OR 08GHH. THE ALTERNATOR CABLE MAY RUB ON THE HIGH PRESSURE POWER STEERING HOSE, POSSIBLY CHAFING ITS INSULATION AND CAUSING AN ELECTRICAL SHORT. Remedy: NAVISTAR WILL INSTALL A BRACKET TO ROUTE THE WIRES AWAY FROM THE POWER STEERING HOSE. NAVISTAR DID NOT PROVIDE AN EXPECTED START DATE FOR THE RECALL, BUT AN INTERIM NOTICE WILL BE MAILED TO OWNERS IF PARTS WILL NOT BE AVAILABLE UNTIL AFTER OCTOBER 14, 2011. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825. THIS RECALL CAMPAIGN HAS BEEN SUPERSEDED BY 12V-196.
NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2010 THROUGH 2013 PAYSTAR, WORKSTAR, TRANSTAR, AND PROSTAR, AND MODEL YEAR 2012 AND 2013 LONESTAR COMMERCIAL TRUCKS MANUFACTURED FROM JUNE 1, 2009, THROUGH APRIL 4, 2012, EQUIPPED WITH A MAXXFORCE 11 OR 13 ENGINE (FEATURE CODE 12UXJ OR 12UXH) AND WITH BOSCH ALTERNATOR FEATURE CODES 08GGN, 08GGR, 08GHG, OR 08GHH. THE ALTERNATOR CABLE MAY RUB ON THE HIGH PRESSURE POWER STEERING HOSE, POSSIBLY CHAFING ITS INSULATION AND CAUSING AN ELECTRICAL SHORT. Remedy: NAVISTAR WILL INSTALL A STANDOFF BRACKET AND IMPROVE HARNESS ROUTING TO BETTER ROUTE THE ALTERNATOR WIRES AWAY FROM THE POWER STEERING HOSE. THE SAFETY RECALL BEGAN ON JULY 16, 2012. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.
Navistar, Inc. is recalling certain model year 2008-2013 International LoneStar, ProStar, and TranStar trucks manufactured February 20, 2008, through July 29, 2013 and equipped with an electronic fifth wheel jaw release system (feature code 0595BAW or 0595BAY). Due to an assembly error, the air lines at the isolation/vent valve may not be oriented correctly. Remedy: Navistar will notify owners, and dealers will inspect the air line routing. If necessary, the air line routing will be corrected free of charge. The recall began on October 10, 2013. Owners may contact Navistar at 1-331-332-1590. Navistar's recall number is 13514.
NAVISTAR IS RECALLING 14,048 MY 2008-2010 LONESTAR AND PROSTAR TRUCKS. THE SERVICE BRAKE AIR LINE THAT RUNS FROM THE TRACTOR PROTECTION VALVE TO THE FAST BRAKE MODULE MAY SEPARATE FROM THE FAST BRAKE MODULE RESULTING IN LOSS OF TRAILER SERVICE BRAKES. Remedy: DEALERS WILL REPLACE THE FAST BRAKE MODULES AND THE AIR LINES RUNNING TO THE MODULE WILL BE REROUTED TO ELIMINATE LINE TENSION CAUSED BY CAB TO FRAME RELATIVE MOTION. THE RECALL BEGAN ON MARCH 20, 2009. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.
NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2009-2010 INTERNATIONAL PROSTAR AND LONESTAR TRUCKS EQUIPPED WITH FEATURE CODE 04AZT ROLL STABILITY CONTROL. THE AIR LINE THAT SUPPLIES THE TRACTION SOLENOID VALVE OF THE ROLL STABILITY CONTROL (RSC) SYSTEM MAY HAVE BEEN CONNECTED TO AN INCORRECT PORT ON THE AIR TANK. THIS CONDITION WILL AFFECT AIR MODULATION TO THE TRAILER BRAKES IF RSC IS ACTIVATED DURING A ROLL STABILITY EVENT. THIS CONDITION AT NO TIME AFFECTS THE NORMAL DESIGN FUNCTION OF THE TRACTOR AND TRAILER SERVICE BRAKES WHEN ACTIVATED BY THE DRIVER, OR THE FUNCTION OF THE TRACTOR RSC SYSTEM. Remedy: DEALERS WILL INSPECT AND RELOCATE THE AIR LINE THAT SUPPLIES THE RSC TRACTION SOLENOID VALVE TO THE CORRECT PORT ON THE AIR TANK. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON FEBRUARY 19, 2010. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.
NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2010 AND 2011 INTERNATIONAL 4300M, 8600, LONESTAR AND PROSTAR BRAND TRUCKS MANUFACTURED FROM MAY 6, 2009 THROUGH MAY 25, 2010. THE FASTENER THAT CLAMPS THE PITMAN ARM TO THE STEERING GEAR SHAFT MAY HAVE BEEN UNDERTORQUED UPON ASSEMBLY. AN UNDER TORQUE CONDITION MAY CAUSE WEAR OF THE INTERCONNECTING SPLINES OF THE ARM AND THE SHAFT POSSIBLY ALLOWING THE PITMAN ARM TO SLIP OVER THE SHAFT RESULTING IN A REDUCTION OF STEERING CONTROL. Remedy: NAVISTAR WILL NOTIFY OWNERS AND DEALERS WILL REPAIR THE VEHICLES FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JULY 9, 2010. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.
NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2008 THROUGH 2011 INTERNATIONAL PROSTAR AND LONESTAR HEAVY TRUCKS MANUFACTURED FROM JANUARY 2, 2007 THROUGH JUNE 1, 2010. THE PASSENGER SIDE WINDSHIELD WIPER LINKAGE ROD MAY SEPARATE FROM EITHER THE WIPER DRIVE ARM OR PASSENGER SIDE PIVOT ASSEMBLY. Remedy: NAVISTAR WILL NOTIFY OWNERS AND INTERNATIONAL DEALERS WILL REPLACE THE WINDSHIELD WIPER LINKAGE ASSEMBLY FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR ABOUT DECEMBER 17, 2010. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.
NAVISTAR HAS NOTIFIED NHTSA OF A DEFECT ON CERTAIN MODEL YEAR 2008-2011 INTERNATIONAL TRUCKS EQUIPPED WITH AN OPTIONAL JUMP START STUD. CORROSION AT THE BASE OF THE STUD MAY CAUSE AN ELECTRICAL SHORT BETWEEN THE STUD AND BATTERY BOX. Remedy: A FINAL REMEDY HAS BEEN ESTABLISHED. NAVISTAR WILL NOTIFY OWNERS, AND DEALERS WILL REPAIR THE VEHICLES BY INSTALLING A NEW JUMP START STUD. REPAIRS WILL BE PREFORMED FREE OF CHARGE. AN INTERIM ACTION WILL INVOLVE THE REMOVAL OF THE JUMP START STUD AND THE CONNECTING CABLE. THE SAFETY RECALL BEGAN ON SEPTEMBER 10, 2010. OWNERS MAY CONTACT INTERNATIONAL DEALERS AT 1-800-448-7825.
Navistar, Inc. (Navistar) is recalling certain 2000-2003 International 8100, 2001-2003 International 9100i, 2001-2007 International 9400i, 2001-2010 International 9200i, 2002-2007, 2009 International 8500, 2003-2007, 2013 International 9900i, 2003-2018 International 8600, 2004, 2007 International 9900iX, 2008-2018 International ProStar, 2010-2011, 2013, 2016 International LoneStar, 2011-2012, 2016 International 4400, 2017-2024 International LT, 2018-2024 International RH, 2019-2021 International LS, 2019-2024 International MV vehicles. The back-up lights offer low visibility when the vehicle is in reverse and bobtail mode. Also, the vehicles have not been equipped with additional unobstructed back-up lights. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 108, "Lamps, Reflective Devices, and Associated Equipment." Remedy: Dealers will replace the existing rear stop/turn signal lights, free of charge. Owner notification letters were mailed May 06, 2024. Owners may contact Navistar's customer service at 1-800-448-7825. Navistar's number for this recall is 23514.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: On certain trucks, the backup lamps could be blocked and may not be visible. As a result, the trucks don't meet the requirements of the Canadian regulations. Note: This recall only affects trucks equipped with a pintle hook lowering bracket and feature code 01WPN, 01 WPS, or 01VAL. Safety Risk: Backup lamps that aren't visible could cause a person not to recognize that the vehicle is backing and increase the risk of a crash. Corrective Actions: Navistar will notify owners by mail and instruct you to take your truck to a dealership to install new tail stop/turn signal lamps with integrated backup lamps.
On certain vehicles equipped with a no-idle heating, ventilation and air conditioning (HVAC) module, the electrical harness supplying power to the module may not be of sufficient size, which could cause a voltage drop in the harness and an increase in resistance and heating at the connector. This could cause a fire, potentially resulting in injury and/or damage to property. Correction: Dealers will install a revised harness.
On certain trucks equipped with the electronic fifth wheel jaw release system, incorrect air line routing could allow the fifth wheel jaw to release without driver input. This could result in a trailer separating from the truck, resulting in a possible hazard to other road users and increasing the risk of a crash causing injury and/or property damage. Correction: Dealers will inspect air line routing and correct if necessary.
On certain trucks equipped with a MaxxForce 11 or 13 engine, the positive alternator cable may rub against the high pressure power steering hose. Continued contact could wear through the alternator cable's insulation, which could cause an electrical short circuit. An electrical short could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will install a bracket to route the alternator wires away from the power steering hose. Note: This recall supersedes recall 2011302.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
On certain trucks equipped with a MaxxForce 11 or 13 engine, the positive alternator cable may rub against the high pressure power steering hose. Continued contact could wear through the alternator cable's insulation, which could cause an electrical short circuit. An electrical short could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will install a bracket to route the alternator wires away from the power steering hose. Note: This recall is superseded by recall 2012147.
On certain trucks, the passenger side windshield wiper linkage rod may separate from either the wiper motor drive arm or the passenger side pivot assembly. If the linkage separates, the passenger side wiper arm will no longer operate which could lead to reduced driver visibility. Decreased driver visibility may increase the risk of a crash possibly resulting in property damage, personal injury, or death. Correction: Dealers will install a redesigned windshield wiper linkage assembly.
On certain trucks, the fastener that clamps the pitman arm to the steering gear shaft may not have been torqued to specifications during vehicle assembly. This could cause wear of the interconnecting splines of the arm and shaft, possibly allowing the pitman arm to slip over the shaft, resulting in a reduction of steering control which could increase the risk of a crash causing property damage, personal injury or death. Correction: Dealers will replace the tubular shaped spacer bracket with a solid spacer block.
On certain vehicles equipped with an optional jump start stud, corrosion at the base of the stud may cause an electrical short between the stud and battery box resulting in a vehicle fire causing property damage, personal injury, or death. Correction: Dealers will install a new redesigned jump start stud.
On certain vehicles, the air line that supplies the traction solenoid valve of the Roll Stability Control (RSC) system may have been connected to an incorrect port of the air tank. This condition will affect air modulation to the trailer brakes if the RSC is activated during a roll stability event. Less than optimal RSC control of the trailer brakes during a roll stability event may increase the risk of a crash which could result in property damage, personal injury or death. Correction: Dealers will inspect and, if necessary, relocate the air line that supplies the RSC traction solenoid valve to the correct port on the air tank.
On certain trucks, the service brake air line between the tractor protection valve and the fast brake module may separate from the fast brake module. This would result in a loss of trailer service brakes, which could increase stopping distances, possibly causing a vehicle crash resulting in property damage, personal injuries or death. Correction: Dealers will replace the fast break module and reroute air lines to eliminate line tension.