Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2011 GMC Canyon, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2011 CHEVROLET COLORADO AND GMC CANYON VEHICLES MANUFACTURED FROM SEPTEMBER 22, 2010, THROUGH NOVEMBER 5, 2010. SOME OF THESE VEHICLES HAVE THE CONDITION IN WHICH THE WINDSHIELD WIPER MOTOR CRANK ARM NUT MAY NOT BE TIGHTENED TO SPECIFICATION. WHEN THE WIPERS ARE OPERATED WITH A BUILD-UP OF SNOW OR ICE, OR IF THE WIPERS ARE OPERATED ON A DRY WINDSHIELD, THE NUT COULD LOOSEN. IF THERE IS SUFFICIENT LOOSENING OF THE NUT, THE WIPERS COULD BECOME INOPERATIVE. Remedy: DEALERS WILL SECURE THE WIPER MOTOR CRANK ARM NUT FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR BEFORE MAY 11, 2011. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438, GMC AT 1-866-996-9463 OR WWW.GMOWNERCENTER.COM.
General Motors is recalling certain model year 2010-2012 Chevrolet Colorado and GMC Canyon vehicles manufactured from November 9, 2009, through August 28, 2012, for failing to comply with the requirements of Federal Motor Vehicle Safety Standard No. 113, "Hood Latch System." The hood may be missing the secondary hood latch. Remedy: General Motors will notify owners and instruct them to inspect their vehicle for the presence of a secondary hood latch. Dealers will replace the hood on any affected vehicles, free of charge. The recall is expected to begin on January 17, 2013. Owners may contact Chevrolet at 1-800-630-2438 or GMC at 1-866-996-9463.
GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2011 CHEVROLET COLORADO AND GMC CANYON PASSENGER VEHICLES EQUIPPED WITH A 2.9 OR 3.7 LITER ENGINE AND A FOUR-SPEED AUTOMATIC TRANSMISSION FOR FAILING TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO 102, "TRANSMISSION SHIFT LEVER SEQUENCE, STARTER INTERLOCK, AND TRANSMISSION BRAKING EFFECT," AND FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 114, "THEFT PROTECTION." THESE VEHICLES MAY HAVE BEEN BUILT WITH AN AUTOMATIC TRANSMISSION ADJUSTMENT CLIP THAT MAY NOT RETAIN THE SHIFT CABLE IN THE CORRECT POSITION. IF THE SHIFT CABLE IS NOT IN THE CORRECT POSITION, THE PRNDL SHIFT LEVER MAY NOT ACCURATELY REFLECT THE POSITION OF THE TRANSMISSION GEAR. THE DRIVER COULD MOVE THE SHIFTER TO "PARK" AND REMOVE THE IGNITION KEY, BUT THE TRANSMISSION GEAR MAY NOT BE IN "PARK." Remedy: GM DEALERS WILL INSTALL A NEW AUTOMATIC TRANSMISSION ADJUSTMENT CLIP FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR ABOUT JULY 19, 2011. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438 AND GMC AT 1-866-996-9463.
GM IS RECALLING CERTAIN MODEL YEAR 2004-2011, CHEVROLET COLORADO, GMC CANYON, MODEL YEAR 2006, ISUZU I-280/I-350, AND MODEL YEAR 2007-2008, I-290/I-370, REGULAR CAB VEHICLES AND EXTENDED CAB VEHICLES WITHOUT A REAR SEAT AND EQUIPPED WITH A FRONT 60/40 SPLIT BENCH SEAT. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 225, "CHILD RESTRAINT ANCHORAGE SYSTEMS." THE TOP TETHER ANCHOR FOR THE FRONT CENTER SEAT IS NOT ACCESSIBLE AND THE OWNER MANUAL DOES NOT INCLUDE INSTRUCTIONS REGARDING HOW TO USE THE TOP TETHER. Remedy: DEALERS WILL CUT A HOLE INTO THE BACK PANEL TRIM COVER TO ALLOW ACCESS TO THE TOP TETHER ANCHOR FOR THE FRONT CENTER SEAT POSITION AND WILL PROVIDE SUPPLEMENTAL INFORMATION AS TO USE IN THE OWNER'S MANUAL. THE MANUFACTURER HAS NOT YET PROVIDED AN OWNER NOTIFICATION SCHEDULE FOR THIS CAMPAIGN. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438, GMC AT 1-866-996-9463, ISUZU AT 1-800-255-6727 OR VISIT GM'S WEBSITE AT WWW.GMOWNERCENTER.COM.
GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2011 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT; CHEVROLET AVALANCHE, COLORADO, EXPRESS, SILVERADO, SUBURBAN, TAHOE; AND GMC CANYON, SIERRA, SAVANA, YUKON AND YUKON XL VEHICLES. THE REAR AXLE CROSS PINS WERE NOT PROPERLY HEAT TREATED AND COULD FRACTURE AND BECOME DISPLACED WITHIN THE REAR AXLE. SHOULD THE PIN SHIFT OUT OF POSITION, IT COULD CREATE AN INTERFERENCE CONDITION AND CAUSE THE REAR AXLE TO LOCK. Remedy: DEALERS WILL INSTALL A NEW REAR AXLE CROSS PIN FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JANUARY 11, 2011. OWNERS MAY CONTACT CADILLAC AT 1-866-982-2339, CHEVROLET AT 1-800-630-2438, GMC AT 1-866-996-9463 AND AT THE OWNER CENTER AT WWW.GMOWNERCENTER.COM.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Certain vehicles fail to conform to Canada Motor Vehicle Safety Standard 113 – Hood Latch System. Specifically, the hood may be missing the secondary hood latch. If the primary hood latch is not engaged, the hood could open unexpectedly. If this occurs while the vehicle is in motion, the hood could contact the windshield and compromise the driver’s ability to see the road and its users, which could result in a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the hood.
On certain vehicles, the automatic transmission shift cable adjustment clip may not retain the cable in the correct position. As such, the shift lever indicator may not accurately reflect the actual transmission gear selection. This could allow the driver to move the shifter to PARK and remove the ignition key, even if the transmission gear is not in the PARK position. Should the vehicle roll away, whether attended or not, it could strike another vehicle, stationary object, or bystander, causing property damage and/or personal injury. Correction: Dealers will replace the automatic transmission shift cable adjustment clip.
On certain vehicles, the windshield wiper motor crank arm nut may not have received adequate tightening torque during vehicle assembly. If the nut loosens, it could result in a loss of windshield wiping capability which, should it occur during a rainy/snowy day, may compromise the driver's ability to see the road and its users, which could result in a crash causing property damage and/or personal injury. Correction: Dealers will torque the wiper motor crank arm nut to specifications.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, the rear axle cross pin was improperly heat treated (during the manufacturing process) and could fracture and become displaced within the rear differential. As a result the driver may hear a banging noise emanating from the rear axle. Also, if the pin shifts out of position it could create an interference and cause the rear axle to lock. This could cause a loss of vehicle control, which could result in a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the rear axle cross pin.
Certain vehicles with regular or extended cab without a rear seat, and equipped with a front 60/40 split bench seat, fail to conform to Canada Motor Vehicle Safety Standard 210.1 - User-ready Tether Anchorages for Restraint Systems. The child restraint top tether anchor for the front centre seat position in these vehicles is not accessible as required by the Standard. Without the top tether anchor, a child restraint may not be properly secured in the vehicle. Correction: If requested by the customers, dealers will modify the back panel trim cover to allow access to the top tether anchor. In addition, owner letters will include an Owner Manual Supplement that describes how to install a child restraint using a top tether in the centre seating position.