Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2011 International Durastar, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Navistar, Inc. (Navistar) is recalling certain model year 2010-2014 International Durastar trucks manufactured May 13, 2009, to June 24, 2013, 2011-2012 International Workstar trucks manufactured November 30, 2010, to September 26, 2011, and 2010-2014 IC Bus HC transit buses manufactured November 19, 2009, to April 24, 2013. The affected vehicles may have an improperly routed engine grid heater power feed cable which can result in the cable contacting the metal edge on the cab. Remedy: Navistar will notify owners, and dealers will secure the power feed cable so that it cannot contact the cab, free of charge. The recall began on August 3, 2015. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 15514.
Navistar, Inc. (Navistar) is recalling certain model year 2011-2014 International DuraStar Trucks and 2012-2014 International TerraStar trucks intended for emergency vehicle operations manufactured from February 25, 2010, through February 18, 2013, and equipped with 2010 MaxxForce 7 V8 diesel engines. In the affected vehicles, the Engine Warning Protection Shutdown (EWPS) was inadvertently re-enabled when the Engine Control Module (ECM) was recalibrated. Remedy: Navistar will notify owners, and dealers will recalibrate the ECM software to ensure that the EWPS is disabled, free of charge. The recall began on March 12, 2014. Owners may contact Navistar at 1-331-332-5000. Navistar's recall number for this campaign is 14505.
Navistar, Inc. (Navistar) is recalling certain model year 2011-2015 International DuraStar, ProStar, TranStar and WorkStar, 2012-2015 International TerraStar, 2013-2015 International LoneStar and IC Bus HC, and 2014-2015 IC Bus AC vehicles. A vehicle double battery jump start or electrical load dump event could result in an overvoltage condition of a component within the HVAC system linear power module (LPM) which is used to control the blower speed. The overvoltage condition could result in the overheating and failure of the LPM. Remedy: Navistar will notify owners, and dealers will replace the LPM with an upgraded one, free of charge. An interim letter was mailed to owners on June 18, 2015. A second notification will mailed when parts become available. The recall began on August 6, 2015. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 15509.
NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2012-2013 IC BUS CE-C, HC, AND INTERNATIONAL 9400 AND CERTAIN MODEL YEAR 2011 THROUGH 2013 INTERNATIONAL DURASTAR, PAYSTAR, WORKSTAR, TRANSTAR, LONESTAR, PROSTAR, 9200, AND 9800, AND CERTAIN MODEL YEAR 2013 INTERNATIONAL 9900, VEHICLES, MANUFACTURED FROM DECEMBER 2, 2010, THROUGH JANUARY 26, 2012, AND EQUIPPED WITH BENDIX ATR-6 TRACTION RELAY VALVES. IN EXTREMELY COLD CONDITIONS, THESE BENDIX RELAY VALVES MAY POTENTIALLY DEVELOP INTERNAL LEAKAGE. INTERNAL LEAKAGE CAN LEAD TO AIR PRESSURE BEING DELIVERED TO AFFECTED PRIMARY OR SECONDARY BRAKES CAUSING CONTINUOUS BRAKE APPLICATION. Remedy: NAVISTAR WILL NOTIFY OWNERS, AND DEALERS WILL PROVIDE A TEMPORARY REPAIR UNTIL BENDIX DEVELOPS A PERMANENT REMEDY. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON APRIL 10, 2012. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.
NAVISTAR IS RECALL CERTAIN MODEL YEAR 2011 AND 2012 INTERNATIONAL DURASTAR, PAYSTAR, WORKSTAR, TRANSTAR, LONESTAR AND PROSTAR COMMERCIAL TRUCKS MANUFACTURED FROM NOVEMBER 5, 2010, THROUGH MARCH 10, 2011, FOR FAILING TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS (ABS)." THE TRAILER ABS FAULT INDICATOR LAMP IN THE INSTRUMENT CLUSTER WILL NOT ILLUMINATE DUE TO A PROGRAMMING OR HARDWARE ISSUE WITH THE BRAKE SYSTEM ELECTRONIC CONTROL UNIT. Remedy: NAVISTAR WILL NOTIFY OWNERS. DEALERS WILL REPROGRAM OR REPLACE THE BRAKE SYSTEM ELECTRONIC CONTROL UNIT FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MAY 12, 2011. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.
Navistar is recalling certain model year 2011-2012 International Lonestar, model year 2012-2013 International Terrastar and model year 2011-2013 International DuraStar, ProStar, TranStar, and WorkStar commercial trucks manufactured from June 1, 2010, through March 7, 2012 and equipped with day cab codes 16CAB, 16030, or 16196 and feature codes 16WCE, 16WCR, 16XWD, 16XWE, 16XWV, 16XXB, 16XXD, 16XXE, 16XXG, or 16XYN sun shades. The sun shade may not be properly secured to the cab roof panel which may result in partial or full separation of the sun shade from the roof panel. Remedy: Navistar will notify owners, and dealers will inspect and strengthen the sun shade mounting, free of charge. The safety recall began on September 10, 2013. Owners may contact Navistar at 1-800-448-7825. Navistar's campaign number is 13505.
NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2009-2011 INTERNATIONAL DURASTAR TRUCKS. THE PARK PAWL IN THE VEHICLE'S TRANSMISSION MAY NOT ENGAGE WHEN THE SHIFT LEVER IN THE VEHICLE CAB IS PLACED IN THE "PARK" POSITION. Remedy: DEALERS WILL INSTALL A RETAINING BAR ON THE END OF THE TRANSMISSION'S IDLER SHAFT TO PERMANENTLY PREVENT THE SHAFT FROM MOVING. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR BEFORE MARCH 18, 2011. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.
NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2011 AND 2012 INTERNATIONAL DURASTAR HEAVY TRUCKS EQUIPPED WITH ENGINE FEATURE CODE 12UXJ AND 12UXH MANUFACTURED FROM JANUARY 21, 2010, THROUGH APRIL 19, 2011. THE BATTERY CABLE INSULATION MAY ABRADE ON THE FRONT SUSPENSION SPRING SHACKLE, POSSIBLY RESULTING IN AN ELECTRICAL SHORT. Remedy: NAVISTAR WILL NOTIFY OWNERS AND DEALERS WILL INSTALL A BRACKET TO ROUTE THE BATTERY CABLES AWAY FROM THE FRONT SUSPENSION SPRING SHACKLE FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JULY 18, 2011. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.
NAVISTAR IS RECALL CERTAIN MODEL YEAR 2011 AND 2012 INTERNATIONAL DURASTAR AND WORKSTAR COMMERCIAL TRUCKS MANUFACTURED FROM OCTOBER 19, 2010, AND FEBRUARY 3, 2011, EQUIPPED WITH GUNITE AUTOMATIC SLACK ADJUSTERS. DUE TO AN INCOMPLETE "KNITTING" OF THE IRON AT THE TIME OF CASTING, INADEQUATE STRUCTURAL INTEGRITY OF THE SLACK ADJUSTER HOUSING CAN OCCUR, WHICH COULD CAUSE THE HOUSING TO BREAK AT THE HANDLE UNDER NORMAL OPERATING LOADS. Remedy: NAVISTAR WILL NOTIFY OWNERS AND DEALERS WILL REPLACE THE SUBJECT SLACK ADJUSTERS FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR ABOUT APRIL 1, 2011. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.
Navistar is recalling certain model year 2012-2013 IC Bus brand model 1300FBC, CE, HC, and RE buses; model year 2011-2013 International brand model Durastar, model year 2013 International brand Workstar trucks; model year 2013 Holiday Rambler brand model Ambassador and Endeavor vehicles; and model year 2013 Monaco brand model Diplomat and Knight vehicles. These vehicles were manufactured August 5, 2010 through September 6, 2012 and are equipped with certain 2011-2013 model year I-6 engines with feature codes 12NUK, 12NUL, 12NUM, 12NUN, 12NUP, 12NUR, 12NUS, 12NUT, 12NUU, 12NUV, 12NUX, 12NUY and 12NUZ. The injection pressure regulator (IPR) harness wire may break due to vibrational damage. This could cause an unexpected shut down of the engine. Remedy: Navistar will notify owners, and dealers will replace the IPR wire connector free of charge. The safety recall began on March 15, 2013. Owners may contact Navistar at 1-800-448-7825.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain vehicles, the engine grid heater power feed cable may have been improperly routed. This could cause the cable to come in contact with a sharp metal edge on the cab causing an electrical short, increasing the risk of fire resulting in injury and/or damage to property. Correction: Dealers will secure the engine grid heater power feed cable and provide clearance to the cab.
On certain vehicles, a double battery (24 volt) jump start or electrical load dump could result in an overvoltage condition of the linear power module (LPM) which is used to control the heater/air conditioning blower motor speed. If this were to occur, this overvoltage condition could lead to the LPM overheating, causing smoke, and increase the risk of fire, which could result in injury and/or damage to property. Correction: Dealers will replace the LPM with an upgraded design.
Certain vehicles destined for emergency vehicle applications and equipped with Maxxforce 7 V8 diesel engines may have been configured inappropriately. Software intended to protect the engine may not have been permanently disabled at time of manufacture and could be inadvertently re-enabled through servicing. Under certain conditions, unintended engine power de-rating and/or shutdown could emergency response operations and put the public at risk. Correction: Dealers will update engine software to disable engine shutdown protocols.
On certain trucks, the sunshade (an exterior visor mounted above the windshield) may not have been fastened to the cab roof correctly during the manufacturing process. A sunshade separating from the vehicle could strike another vehicle, a stationary object, or a bystander, causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, secure the sunshade mounts.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, the Injection Pressure Regulator (IPR) electrical wire may break due to vibration damage at the crimp/wire connection. This could cause an unexpected engine shut down without warning. Loss of vehicle propulsion, in conjunction with traffic and road condition, and the driver’s reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will install a redesigned IPR wire connector.
On certain vehicles equipped with Bendix ATR-6 Antilock Traction Relay valves, in extremely cold conditions (at or below -18 degrees Celsius), internal ATR valve leakage can occur. This could cause unintended brake application, which could overheat the affected brakes and cause a fire. Also, in certain low traction conditions, unexpected brake application can cause a loss of vehicle control and a crash. These issues could result in property damage and/or personal injury. Correction: Dealers will update the cover assembly on the ATR valves.
On certain trucks, the battery cables may have been routed incorrectly and could chafe against the front suspension spring shackle. Continued contact could wear through the cable's insulation, which could result in an electrical short circuit. An electrical short could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will install a bracket to route the battery cables away from the front suspension spring shackles.
Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard 121 - Air Brake Systems. The trailer Antilock Brake System (ABS) fault indicator lamp may not illuminate if a trailer ABS fault occurs, due to a programming or hardware issue with the brake system electronic control unit. An inoperable trailer ABS fault indicator may prevent the driver from being aware of a trailer ABS fault condition, thereby increasing the risk of a crash resulting in property damage and/or personal injury. Correction: Dealers will reprogram or replace the ABS electronic control unit.
On certain vehicles, the slack adjuster housings may have been manufactured incorrectly, which could allow the housings to fracture and fail. As a result, the wheel brake to which the slack adjuster is attached would no longer function, which could increase vehicle stopping distances. Should a steer axle slack adjuster fail, it could also cause the vehicle to pull to one side during braking. Either problem could result in a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the slack adjusters.