Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2011 Winnebago View, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Winnebago is recalling certain model year 2009-2013 model Era motorhomes, 2010-2013 Via and Itasca Reyo motorhomes, and 2011-2013 View and Itasca Navion motorhomes; manufactured November 13, 2007, through August 20, 2012. The proper fuses were not installed for the refrigerator circuits. Remedy: Winnebago will notify owners, and dealers will replace the fuses. The recall began on December 21, 2012. Consumers may contact Winnebago Industries owner relations at 1-641-585-6939.
WINNEBAGO IS RECALLING CERTAIN MODEL YEAR 2006 THROUGH 2011 WINNEBAGO VIEW AND ITASCA NAVION MOTOR HOMES BECAUSE THE DINETTE AREA SEAT BELT RESTRAINTS ON THOSE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." IN A COLLISION, THE GENERATED CRASH FORCES CAN CAUSE THE RESTRAINT'S ATTACHMENT TO TEAR AND ALLOW THE ANCHOR TO SEPARATE FROM THE BODY OF THE VEHICLE. Remedy: WINNEBAGO WILL ADD ADDITIONAL SEAT BELT ANCHORAGES FREE OF CHARGE. THE SAFETY RECALL BEGAN ON NOVEMBER 12, 2010. OWNERS MAY CONTACT WINNEBAGO AT 1-800-537-1885.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
On certain motorhomes, incorrect fuses were installed in the refrigerator 12V circuits. A 5-amp fuse was installed in the lamp/fan circuit instead of a 3-amp fuse, and a 20-amp fuse was installed in the heating element circuit instead of a 15-amp fuse. These oversized fuses fail to provide proper circuit protection, which could result in a fire causing property damage and/or personal injury. Correction: Dealers will replace the affected fuses.
On certain motorhomes, the dinette area seatbelts may not conform to Canada Motor Vehicle Safety Standard 210 - Seatbelt Assembly Anchorages. Two seatbelt assemblies were placed side by side using three anchorage bolts rather than four bolts. During a crash, stress can cause the attachment to tear and allow the anchor to separate from the body of the vehicle. Failure of the seatbelt anchorage to restrain the occupant as intended would increase the risk of personal injuries during a crash. Correction: Dealers will install additional seatbelt anchorage bolts.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain