Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2016 International Workstar, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Navistar, Inc. (Navistar) is recalling certain 2019-2021 International MV, 2020-2021 International HV, 2014-2020 International DuraStar and 2015-2018 International WorkStar vehicles. When the parking brake is applied and the automatic transmission is still in the drive or reverse position and the stationary PTO switch is engaged by the operator, the engine may rev and overcome the parking brake's ability to keep the vehicle from moving. Remedy: Navistar will notify owners, and dealers will update the parameters in the Cummins ECM for feature codes 12VXT or 12VXU that enables the PTO neutral interlock, free of charge. The recall began February 17, 2021. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 20510.
Navistar, Inc. (Navistar) is recalling certain 2016 International DuraStar, LoneStar, ProStar, TerraStar, TranStar, WorkStar, 9900i, and IC Bus HC vehicles equipped with certain Spicer D or E series steer axles. The castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen. Remedy: Navistar will notify owners, and dealers will inspect the torque of the castellated nut and tie rod, tightening it as necessary, free of charge. The recall began on November 8, 2017. Owners may contact Navistar customer service at 1-331-332-1590. Navistar's number for this recall is 17507.
Navistar, Inc. (Navistar) is recalling certain model year 2015-2016 International 9900, DuraStar, LoneStar, PayStar, ProStar, WorkStar and 2015 International TranStar and IC Bus CE vehicles equipped with a Haldex air braking system. The affected brake actuators may have been manufactured with an incomplete attachment of the internal rubber diaphragm to the actuation mechanism. This could cause dragging or overheated brakes. Remedy: Navistar will notify owners, and dealers will replace the Haldex Life Seal Brake chambers, free of charge. The recall began on June 19, 2015. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 15504. Note: This recall supersedes recall 14V-806.
Navistar, Inc. (Navistar) is recalling certain model year 2016 International PayStar trucks manufactured January 19, 2015, to January 20, 2015, and 2016 International WorkStar trucks manufactured on January 19, 2015. The affected vehicles are equipped with Meritor MT-40-14X rear drive axles that may circulate an inadequate amount of lubricant to the wheel end hub assembly. Remedy: Navistar has already repaired the affected vehicles, free of charge. The recall was completed in April 2015. Owners may contact Navistar customer service at 1-800-448-7825.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: On certain trucks equipped with an automatic transmission, when the engine RPM increases for the stationary power take off (PTO), it can overcome the parking brake if the transmission is in drive or reverse gear. As a result, the truck may move suddenly. Safety Risk: Sudden and unexpected movement of the truck could increase the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct you to take your truck to a dealer to update the engine control module software to enable the PTO neutral interlock.
On certain vehicles, the castellated nut and cotter pin on the steer axle may not have been tightened to specification. This could cause the tie rod to become loose in the steer axle, which would result in audible noise and/or looseness in steering. If the vehicle were continued to be operated in this condition, the tie rod could disconnect from the knuckle, resulting in a complete loss of control of a vehicle wheel, which would increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the torque of the castellated nuts on the tie rod, and replace the tie rod stud and knuckle as necessary.
Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 108 - Lighting System and Retroreflective Devices. For vehicles built with the snow plow option, the necessary body controller programming for the snow plow’s Day Time Running Lights (DRLs) may not have been installed during assembly. This could cause the snow plow DRLs to not illuminate when the headlight switch is off, which is contrary to the requirements of the standard. This could reduce vehicle conspicuity during daylight hours, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will recalibrate the body control module.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
On certain vehicles, brake chamber diaphragm(s) may not be properly seated. This could lead to brake drag, causing brake overheating or unintended spring brake application. These issues could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will replace the brake chambers. Note: This is an expansion of recall 2014-573.