Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2016 Mercedes-Benz Sprinter, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: On certain vehicles, the power steering return hoses may detach at their connection points. If this happens, power steering fluid can leak. This would result in a loss of power steering assist and power steering fluid could leak onto the road. Note: This is an expansion of Mercedes-Benz Recall 4695079 (Transport Canada Recall No. 2020-517). Safety Risk: A loss of power steering assist may result in a sudden increase in steering effort, especially at low speeds. This could increase the risk of a crash. A power steering fluid leak could create a road hazard. Corrective Actions: Mercedes-Benz will notify owners by mail and instruct you to take your vehicle to a dealer to check the power steering return hose connections. Dealers will install a clamp at the connection point, if needed.
Issue: On certain recreational vehicles (RVs) and camper van conversions, moisture could cause a rear wheel speed sensor to fail. If this happens, the Electronic Stability Program (ESP) control unit may not work properly. Note: A malfunction of the ESP control unit can cause the ESP or ABS warning lights to turn on, and a "workshop assistance" message could appear in the instrument cluster. Safety Risk: A stability control system that does not work properly could increase the risk of a crash. Corrective Actions: Mercedes-Benz will notify owners by mail and instruct you to take your vehicle to a dealer to replace the rear wheel speed sensors with an improved part.
This recall was replaced by Transport Canada Recall No. 2021-216. Issue: On certain vehicles, the power steering return hoses may detach at their connection points. If this happens, power steering fluid can leak. This would result in a loss of power steering assist and power steering fluid could leak onto the road. Safety Risk: A loss of power steering assist may result in a sudden increase in steering effort, especially at low speeds. This could increase the risk of a crash. A power steering fluid leak could create a road hazard. Corrective Actions: Mercedes-Benz will notify owners by mail and instruct you to take your vehicle to a dealer to check the power steering return hose connections. Dealers will install a clamp at the connection point, if needed.
Issue: On certain cargo vans, an additional bench seat may have been installed incorrectly. In specific, the seat may not be properly attached and may not have protection from corrosion. Over time, this could cause the seat to loosen and detach. Note: This recall only affects vans that were sold by Mercedes-Benz Mississauga, and up-fitted by Total Autoglass. Safety Risk: A seat that is loose or detaches could increase the risk of injury in a crash. Corrective Actions: Mercedes-Benz will notify owners by mail and instruct you to take your vehicle to a dealer to inspect your van. The vehicle will be repaired as necessary. Mercedes-Benz advises that these bench seats should not be used until an inspection is completed.
On certain motorhomes built on a Mercedes Sprinter cutaway or Mercedes chassis, the radio volume control module connected to the Mercedes chassis electrical system can cause improper operation of various electrical systems. This can result in an engine stall, and/or interference with the proper operation of the airbag system. Additionally, dash warning lights, exterior running lights can also be affected. Failure of these electrical systems will increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will remove the radio volume module and harness from the chassis electrical system.
On certain vehicles, a reinforcement plate and the protective bracket may not have been installed on the airbag control unit. This could cause the airbag control unit to become damaged in the event of a frontal impact. If this occurs, this could prevent the airbag system to work properly in the event of a secondary impact requiring the deployment of additional airbags which could increasing the risk of injury to the occupants. Correction: Dealers will install the reinforcement plate with the protective bracket.
We checked the EU Safety Gate for recall alerts naming this model and its production years.
Source: EU Safety Gate (European Commission) · CC BY 4.0, © European Union
A chemical change in the active substance in the front airbag gas generator can cause an increase in the internal pressure. In the event of an accident, the gas generator may burst and injure the occupants of the vehicle with metal fragments. Furthermore, the airbag will not unfold and protect properly in this situation. Production: 2006-2015. Types: e1*2001/116*0354/04; e1*2007/46*0279*02 - e1*2007/46*0301*14 - e1*2007/46*0279*09 - e1*2007/46*0301*13.
How cars of this model and year did at Norway's periodic inspection, across a full year of tests.
Source: Statens vegvesen, periodic inspections (EU-kontroll) · CC BY 4.0