Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2017 Kia Sedona, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Kia Motors America (Kia) is recalling certain 2015-2018 Kia Sedona vehicles equipped with a power sliding door (PSD). The PSD may not auto-reverse when its closing is obstructed. Remedy: Kia will notify owners, and dealers will reprogram the PSD module software, free of charge. The recall began on June 18, 2018. Owners may contact Kia customer service at 1-800-333-4542. Kia's number for this recall is SC164.
Kia Motors America (Kia) is recalling certain 2017-2019 Sedona, Soul, Soul EV, 2017-2018 Forte, and 2017 Forte Koup vehicles. The Air Bag Control Unit (ACU) cover may contact a memory chip on the printed circuit board and damage the electrical circuit. Circuit damage may result in deactivated air bags that will not deploy in a crash. Remedy: Dealers will inspect the ACU, and either update the software or replace the unit, as necessary. Repairs will be performed free of charge. Owner notification letters were mailed March 21, 2022. Owners may contact Kia customer service at 1-800-333-4542. Kia's number for this recall is SC226.
Kia Motors America (Kia) is recalling certain 2015-2017 Sedona vehicles. The Smart Junction Box (SJB) software logic may not properly interpret the signals received from the multifunction switch, which could cause the turn signal to activate in the opposite direction of what the driver intended. Remedy: Dealers will update the SJB software, free of charge. Owner notification letters were mailed November 12, 2021. Owners may contact Kia customer service at 1-800-333-4542. Kia's number for this recall is SC217.
Kia Motors America (Kia) is recalling certain 2015-2018 Sedona vehicles equipped with manually-adjusted front passenger seats. Over time, the Occupant Detection System (ODS) wiring harness located underneath the front passenger seat may break from the seat being occupied. Remedy: Kia will notify owners, and dealers will remove the wire harness clip to prevent the wiring harness from breaking. If the harness is found damaged, the front passenger seat cushion will be replaced. These repairs will be performed free of charge. The recall began March 19, 2019. Owners may contact Kia customer service at 1-800-333-4542. Kia's number for this recall is SC175.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: On certain vehicles, the compliance label may be missing information in French. The words listed on the label for "Tires", "Rims", "Front" and "Rear" appear in English only, when they should be listed as "Tires/Pneus", "Rims/Jantes", "Front/Avant" and "Rear/Arriere". Canadian regulations require this information to be listed on the label in both English and French. Safety Risk: These small errors do not affect vehicle safety. Corrective Actions: This is not a recall. Kia has corrected the compliance label for all new vehicles.
Issue: On certain vehicles, a defect in the airbag control unit could cause the airbag warning light to turn on. If this happens, the airbag system may not work properly, and the airbags may not inflate in a crash. Safety Risk: An airbag system that does not work properly could create an increased risk of injury in a crash. Corrective Actions: Kia will notify owners by mail and instruct you to take your vehicle to a dealer to update the airbag control unit software. If the airbag warning light is on because of diagnostic trouble code B1620, the dealer will replace the airbag control unit.
Issue: Certain vehicles may be equipped with an accessory trailer wiring harness that could fail. Over time, water could leak into the control module and cause a short circuit. If this happens, there could be loss of the trailer lights. Note: This recall affects trailer wiring harness kits that may have been ordered at the time of a vehicle purchase, or purchased separately from a dealer as an aftermarket accessory. Safety Risk: A loss of trailer lights could make the trailer less visible. In addition, other drivers may not recognize that the vehicle ahead is braking or intends to turn. This could increase the risk of a crash. Corrective Actions: Kia will notify owners by mail and instruct you to take your vehicle to a dealer to inspect the trailer wiring harness. If the harness is from the lot (batch) affected by this problem, the dealer will replace it. Kia recommends that you should always check to ensure that trailer lights work properly before towing.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
Issue: On certain vehicles, an intermittent problem could cause the turn signals to activate in the opposite direction from what a driver intends. For example, when the driver uses the right turn signal, the left signal could turn on. Safety Risk: Turn signals that do not work properly may cause confusion and could increase the risk of a crash. Corrective Action: Kia will notify owners by mail and instruct you to bring your vehicle to a dealer to update the Smart Junction Box software.
Issue: On certain vehicles, the wiring for the Occupant Detection System (ODS) could break. This would cause the airbag system to not turn off the airbag when an infant or child is seated in the front passenger seat. This problem only affects vehicles with a manual front-passenger seat. Safety Risk: In a crash, an airbag that deploys in front of an infant or child increases the risk of injury. Corrective Actions: The company will notify owners by mail. Owners will be instructed to take their vehicle to a dealer to remove a wiring harness clip. This will prevent the wire from breaking. If the wiring is found damaged, the dealer will replace the front passenger seat cushion. Note: If the wiring breaks, the SRS airbag warning light will come on and the "Passenger Airbag Off" indicator will not turn on.
On certain vehicles, the power sliding door control module may not be calibrated correctly. As a result, a closing door may not stop and reverse direction if blocked by an object, increasing the risk of injury to vehicle occupants. Correction: Dealers will reprogram the power sliding door control module software.