Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2017 Toyota Tundra, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2008-2022 Sequoia and 2007-2021 Tundra vehicles. The power steering gear assembly may have been manufactured incorrectly, which can result in an oil leak. Remedy: Dealers will inspect and replace the power steering gear assembly as necessary, free of charge. Owner notification letters were mailed on January 21, 2022. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's numbers for this recall are 21TB10 and 21TA10.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain JTEKT power steering gear assembly service parts for 2007-2021 Tundra and 2008-2022 Sequoia, part numbers 44250-0C160, 44250-0C131, 44250-0C170, and 11250-0C121. The power steering gear assembly may have been manufactured incorrectly, which can result in an oil leak. Remedy: Dealers will inspect and replace the power steering gear assembly, free of charge. Owner notification letters were mailed on February 17, 2022. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's number for this recall is 21TH01.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2017-2018 Toyota 4Runner and Tundra, 2018 Toyota Highlander, RAV4 and Lexus GX460 and 2017 Toyota Sienna and Tacoma vehicles. These vehicles may have incorrect load carrying capacity modification labels. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 110, "Tire Selection and Rims." Remedy: Toyota will notify owners and provide them with corrected labels, free of charge. The recall began on January 23, 2018. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's numbers for this recall are H0Z for Toyota vehicles, and HLF for Lexus vehicles.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2016-2017 Tundra vehicles equipped with a resin rear step bumper and resin reinforcement brackets (vehicles with chrome step bumpers are not affected). In the event of an impact to the corner of the bumper, the resin bracket may be damaged but not be noticed. Remedy: Toyota will notify owners, and dealers will replace the resin rear bumper reinforcement brackets with steel ones, and replace the rear bumper tread, free of charge. The recall began on May 21, 2017. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's number for this recall is H0C.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2017 Toyota Tundra vehicles. One of the rear split bench seat leg brackets may not have been properly tightened to the vehicle's floor pan, possibly allowing the seat to move in a crash. A vehicle with an improperly tightened seat leg bracket could fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 207, "Seating Systems," 210, "Seat Belt Assembly Anchorages," and 225, "Child restraint anchorage systems." Remedy: Toyota will notify owners, and dealers will tighten the five seat leg bracket bolts, as necessary, free of charge. The recall is expected to begin March 2018. Owners may contact Toyota customer service at 1-888-270-9371. Toyota's number for this recall is J0I.
Southeast Toyota Distributors, LLC (SET) is recalling certain model year 2013-2017 Toyota Tundra and Sequoia vehicles accessorized with Southeast Toyota accessory 20-inch Rockstar wheels installed by Southeast Toyota or a Southeast Toyota dealer. The Rockstar wheels were installed with lugnuts that may crack and detach. Remedy: SET will notify owners, and dealers will install new replacement lugnuts, free of charge. The recall began June 23, 2017. Owners may contact SET customer service at 1-866-405-4226. SET's number for this recall is SET17A.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable may not have enough heat protection and could be damaged by high temperatures. If this happens, the cable could short circuit while plugged in, and cause the wiring to overheat or melt. Note: This recall only affects the following block heater/cord part numbers: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903 Safety Risk: Engine block heater wiring that overheats or melts could create the risk of a fire. Corrective Actions: Toyota recommends that you should stop using the engine block heater immediately. Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. For some vehicles, the corrective actions for this recall are under development. For others, a new engine block heater cannot be installed, and the owner will receive a refund of the purchase price of the engine block heater.
Issue: On certain vehicles, a defect in the steering gear assembly could cause it to leak power steering fluid. If this happens, there could be a loss of power steering assist. Note: For 2007-2020 models, this recall only affects 41 vehicles that had a replacement steering gear installed in 2021. Safety Risk: A loss of power steering assist may result in a sudden increase in steering effort, especially at low speeds. This could increase the risk of a crash. Corrective Actions: Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to inspect, and if necessary, replace power steering gear assembly.
We checked the EU Safety Gate for recall alerts naming this model and its production years.
Source: EU Safety Gate (European Commission) · CC BY 4.0, © European Union
The cabling of the front turn signals has been incorrectly assembled. When the front warning lights are activated, this results in reduced brightness of the headlamps and this may increase the risk of an accident. Production: 22.02.2017 - 29.05.2020. Types: Individual approval.
The screws on the left-hand rear seat may not have been fitted correctly. Production: The vehicles affected were produced between 9 January 2017 and 25 February 2017. . Types: Type: USK5#.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
Certain vehicles may fail to conform to Canada Motor Vehicle Safety Standard CMVSS 207 - Anchorage of Seats, CMVSS 210 - Seat Belt Anchorages, CMVSS 210.1 - User-ready Tether Anchorages for Restraint Systems and Booster Seats, and CMVSS 210.2 - Lower Universal Anchorage Systems for Restraint Systems and Booster Seats. One or more of the bolts fixing the left hand rear split seat bracket sub-assemblies to the floor pan may not have been tightened properly during assembly. This could allow the seat to move in the event of a crash, increasing the risk of injury to the seat occupant. Correction: Dealers will retighten the five seat leg bracket bolts.
On certain vehicles, the electrical power cords of some dealer installed block heaters may have been improperly manufactured, causing the wires to contact each other, resulting in a short circuit. A short circuit could lead to a fire which would increase the risk of injury and/or damage to property. Correction: For vehicles where the subject block heater was approved for installation, the dealer will replace the block heater assembly with a new one of an improved design. For vehicles where the subject block heater was not approved for installation, dealers will remove the block heater assembly. In the interim, until the remedy can be performed, dealers will cut the plug end from the block heater cord to disable the block heater's operation.
On certain vehicles equipped with the plastic rear step bumper, the resin reinforcement brackets that secure the step corners of the bumper could become damaged after a rear impact. If a person were to use the rear bumper steps with damaged resin reinforcement brackets, part of the bumper could break off which could cause the person to fall, increasing the risk of injury. Correction: Dealers will replace the resin reinforcement brackets with steel reinforcement brackets. In addition, the rear bumper tread covers will also be replaced.