Loading NHTSA data…
Loading NHTSA data…
Recalls, inspection results and owner complaints for the 2024 Lucid AIR, from official sources in the US, Canada and Europe. To check one specific car, enter its VIN or plate.
We checked recall campaigns for this vehicle, or for its model where the register works by model.
Source: NHTSA (US Department of Transportation) · US public domain
Lucid USA, Inc. (Lucid) is recalling certain 2022-2024 Air vehicles running software release versions 2.1.2 through 2.1.26. The software may cause a fault while the adaptive cruise control is on, resulting in a loss of drive power. Remedy: Lucid released an over-the-air (OTA) software update in October 2023, free of charge. Owner notification letters are expected to be mailed March 8, 2024. Owners may contact Lucid customer service at 1-888-995-8243. Lucid's number for this recall is SR-24-02-0.
Lucid USA, Inc. (Lucid) is recalling certain 2022-2024 Air vehicles. The high voltage coolant heater may fail to defrost the windshield. Remedy: Lucid has released an over-the-air software update to identify a high voltage coolant heater failure and provide a warning to the driver. High voltage coolant heaters that fail will be replaced. Software updates and repairs will be performed free of charge. Owner notification letters were mailed August 5, 2024. Owners may contact Lucid customer service at 1-888-995-8243. Lucid's number for this recall is SR-24-04-0. This recall is an expansion of Recall 24V-011.
Lucid USA, Inc. (Lucid) is recalling certain 2024-2025 Air Pure rear wheel drive vehicles. The rear subframe wiring harness may be too short, straining the electrical connection and causing power loss to the rear drive unit (RDU). Remedy: Lucid will replace the wiring harness, free of charge. Owner notification letters were mailed December 18, 2024. Owners may contact Lucid at 1-888-995-8243. Lucid's number for this recall is SR-24-05-0.
Lucid USA, Inc. (Lucid) is recalling certain 2024-2026 Air vehicles equipped with Pure Rear-Wheel Drive. Improperly secured bolts may allow the half-shaft to disconnect from the drive unit. Remedy: Lucid will remove, inspect, and install new bolts, free of charge. Owner notification letters were mailed December 3, 2025. Owners may contact Lucid at 1-888-995-8243. Lucid's number for this recall is SR-25-03-0.
Lucid USA, Inc. (Lucid) is recalling certain 2022-2025 Air vehicles operating a software version prior to 2.8.0. The lower console display may fail to show a rearview camera image or may show a delayed, inaccurate image of what is behind the vehicle. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility." Remedy: Lucid has released an over-the-air (OTA) software update, free of charge. Owner notification letters were mailed December 3, 2025. Owners may contact Lucid at 1-888-995-8243. Lucid's number for this recall is SR-25-04-0. The information in your report suggests that Lucid may have been aware of this issue more than five business days before filing a report with NHTSA. Please be reminded that under Federal law, this agency is to be notified of all safety defect and/or noncompliance decisions within five business days. 49 CFR 573.6 Significant civil penalties can be assessed for this violation.
Lucid USA, Inc. (Lucid) is recalling certain 2022-2026 Air vehicles equipped with an AD02 package and operating a software version from 2.8.0 through 2.8.16. The rearview camera image may not display when the vehicle is placed in reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility." Remedy: Lucid has released an over-the-air (OTA) software update, free of charge. Owner notification letters were mailed March 4, 2026. Owners may contact Lucid at 1-888-995-8243. Lucid's number for this recall is SR-26-01-0.
Lucid USA, Inc. (Lucid) is recalling certain 2024-2026 Air vehicles equipped with Pure Rear-Wheel Drive. Improperly secured bolts may allow the half-shaft to disconnect from the drive unit. Remedy: Lucid will remove and install new bolts, free of charge. Owner notification letters were mailed May 18, 2026. Owners may contact Lucid at 1-888-995-8243. Lucid's number for this recall is SR-26-03-0. This recall is an expansion of previous NHTSA recall number 25V669.
Lucid USA, Inc. (Lucid) is recalling certain 2024-2025 Air vehicles equipped with rear-wheel drive. The Gen 4 inverter may experience internal friction and become damaged, causing a loss of drive power. Remedy: Lucid will release an over-the-air (OTA) software update to continually inspect for an inverter failure. If a failure is detected Lucid will replace the inverter, free of charge. Owner notification letters were mailed July 8, 2026. Owners may contact Lucid at 1-888-995-8243. Lucid's number for this recall is SR-26-05-0.
Lucid USA, Inc. (Lucid) is recalling certain 2022-2026 Air vehicles. The exterior lighting circuit may have insufficient overcurrent protection, allowing the circuit to overheat. Remedy: Owners are advised to park their vehicle outside and away from structures until the recall remedy is completed. Lucid has released an over-the-air (OTA) software update, free of charge. Owner notification letters were mailed September 25, 2026. Owners may contact Lucid at 1-888-995-8243. Lucid's number for this recall is SR-26-06-0.
We checked Transport Canada's recall database for this make, model and year.
Source: Transport Canada Vehicle Recalls Database · Open Government Licence – Canada
Issue: On certain vehicles, the circuits for the exterior lighting may not have proper circuit protection. As a result, the wiring and components could overheat and melt, and the exterior lights may not work. Safety Risk: Wiring and/or components that overheat and melt can create the risk of a fire. Exterior lights that don't work could increase the risk of a crash. Corrective Actions: To reduce the safety risk, Lucid advises that you should park your vehicle outdoors and away from other vehicles or structures until the recall repairs have been completed. Lucid will notify owners by mail. Lucid has sent a wireless over-the-air software update to each vehicle. If you haven't yet accepted the software update, Lucid encourages you to do so. If you need assistance with this update, you should contact Lucid customer care or a Lucid service center. There is no further action needed if your vehicle has software version 2.10.0 or a later release.
Issue: On certain vehicles, the inverter for the drive unit could fail and cause a loss of power to the wheels. Note: This recall only affects certain Air Pure rear-wheel drive models. Safety Risk: A sudden loss of power to the wheels could increase the risk of a crash. Corrective Actions: Lucid will notify owners by mail and send a wireless over-the-air software update to each vehicle to install an advanced diagnostic software that will monitor the inverter and warn you if it detects a problem. If you see this warning, you should contact a Lucid Service Center or Lucid Customer Care to arrange for the replacement of the inverter, as necessary.
Issue: On certain vehicles, the bolts securing the axle shafts to the drive unit may not have been tightened properly. As a result, the axle shaft(s) could separate from the drive unit and cause a sudden loss of power to the wheels. Note: This recall is an expansion of Transport Canada recall no. 2025-535. This recall only affects certain Air Pure rear-wheel drive models. Safety Risk: A loss of power to the wheels could increase the risk of a crash. Corrective Actions: Lucid will notify owners by mail and advise you to contact a Lucid Service Center or Lucid Customer Care to schedule an appointment to replace the axle shaft bolts.
Problems owners of this model reported to NHTSA, grouped by component.
Source: NHTSA (US Department of Transportation) · US public domain
Crash-test ratings from NHTSA's New Car Assessment Program.
Source: NHTSA (US Department of Transportation) · US public domain
Issue: On certain vehicles, a software problem could cause the rearview camera image not to appear on the display. Note: This problem would cause a "Camera Error. Turn your vehicle off and on again" message to be displayed. This recall only affects vehicles equipped with the optional DreamDrive Pro package. Safety Risk: A rearview camera image that doesn't display could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash. Corrective Actions: Lucid will notify owners by mail. Lucid has sent a wireless over-the-air software update to each vehicle. If you haven't yet accepted the software update, Lucid encourages you to do so. If you need assistance with this update, you should contact Lucid customer care or a Lucid service center. There is no further action needed if your vehicle has software version 2.8.17 or a later release.
Issue: On a small number of vehicles, the bolts securing the axle shafts to the drive unit may not have been tightened properly. As a result, the axle shaft(s) could separate from the drive unit and cause a sudden loss of power to the wheels. Note: This recall only affects certain Air Pure rear-wheel drive models. Safety Risk: A loss of power to the wheels could increase the risk of a crash. Corrective Actions: Lucid will notify owners by email and advise you to contact a Lucid Service Center or Lucid Customer Care to schedule an appointment to inspect and, if necessary, replace the axle shaft bolts.
Issue: On a small number of vehicles, a software problem could cause the rearview camera image to be delayed or not to appear on the display. Canadian regulations require the rearview image to display when the transmission is shifted into reverse gear. Safety Risk: A rearview camera image that doesn't display could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash. Corrective Actions: Lucid will notify owners by email. Lucid has sent a wireless over-the-air software update to each vehicle. If you haven't yet accepted the software update, Lucid encourages you to do so. If you need assistance with this update, you should contact Lucid customer care or a Lucid service center. There is no further action needed if your vehicle has software version 2.8.0 or a later release.
Issue: This recall is for certain all-weather floor mats that were sold as a Lucid genuine accessory. On certain vehicles, the accelerator pedal could get stuck on the floor mat. If this happens, the vehicle may not slow down when you release the accelerator pedal. Note: This recall is not being conducted under the requirements of the Motor Vehicle Safety Act. Safety Risk: A stuck accelerator pedal could cause an unintended acceleration and increase the risk of a crash. Corrective Actions: To reduce the safety risk, Lucid advises you to remove the driver's all-weather floor mat. Lucid will notify owners by email and provide you with instructions for how to inspect the all-weather floor mats. You should contact Lucid customer care or a Lucid service center if you would like help inspecting the all-weather floor mats. Lucid will reimburse owners of the affected all-weather floor mats.
Issue: On a small number of vehicles, the wiring harness for the rear drive unit may be too short and could disconnect. If this happens, there could be a loss of power to the wheels. Note: This recall only affects Air Pure rear-wheel drive models. Safety Risk: A loss of power to the wheels could increase the risk of a crash. Corrective Actions: Lucid will notify owners by email and advise you to contact a Lucid Service Center or Lucid Customer Care to schedule an appointment to replace the rear drive unit wiring harness.
Issue: Under certain conditions, a software problem could cause a loss of power to the wheels. Safety Risk: A loss of power to the wheels could increase the risk of a crash. Corrective Actions: Lucid will notify owners by e-mail. Lucid has sent a wireless over-the-air software update to each vehicle. If you haven't yet accepted the software update, Lucid encourages you to do so. If you need assistance with this update, you should contact Lucid customer care or a Lucid service center. There is no further action needed if your vehicle has software version 2.1.30 or a later release.